Admiral Wire, Harness, Power Cord

This replacement wire harness routes power and signals to the freezer compartment components to restore reliable electrical connections and safe operation. It replaces damaged or worn wiring that can interrupt component function. What it does:

• Provides correct electrical routing for freezer components such as lights, fans, thermostats and defrost/heater circuits
• Restores lost or intermittent power caused by damaged, frayed or broken wiring
• Prevents shorts and poor connections that can cause inconsistent operation or safety concerns
• Helps re-establish reliable communication between control components and the freezer section

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Inspect grommets and routing holes; protect the harness from sharp edges and pinch points
• Ensure all connectors are fully seated and secure; replace any damaged clips or insulation

This wire harness connects the compressor to the refrigerator's electrical system so the compressor can receive power and signals. Replaces a damaged or worn compressor lead to restore reliable electrical connections. What it does:

• Provides the electrical connection between the compressor and the appliance wiring/controls
• Ensures proper power and signal transmission so the compressor can start and run
• Common replacement when wiring is burnt, corroded, frayed, or has loose/cracked connectors
• Can help address issues where the compressor does not receive power or has intermittent operation

• One (1) compressor wire harness as shown

• Disconnect power to the appliance before attempting any repair to avoid shock or injury
• Inspect connectors and routing; match connector types and wire colors before installing
• Replace only with the exact harness to ensure correct fit and secure connections

This control wire harness connects the appliance control board to sensors, switches and powered components to restore electrical communication and proper function. It replaces a damaged or loose harness to help resolve intermittent or non-responsive controls. What it does:

• Carries power and low-voltage control signals between the main control board and components.
• Restores operation when frayed, burned, or cracked wiring causes intermittent circuits or loss of specific functions.
• Helps stop faults caused by broken connector tabs, corroded terminals, or detached plugs.
• Resolves error codes or unresponsive buttons that trace back to wiring faults.

• Disconnect power (unplug or switch off breaker) before starting; shock hazard exists.
• Compare the new harness to the original for connector type and routing before installing.
• Route and secure the harness exactly as the original using existing clips/retainers to avoid pinching or heat exposure.

This control wire harness connects the appliance's control board to switches, sensors and motors, restoring electrical communication for proper operation. It replaces a damaged or burned harness to help resolve intermittent or non-functioning controls. What it does:

• Provides the routed wiring and connector plugs that link the control board to components.
• Restores lost or intermittent electrical connections that can cause the unit to stop responding or display control errors.
• Replaces harnesses with damaged insulation, broken wires, or melted connectors that create faults or safety concerns.
• Ensures correct pin-to-pin connections when matched to the original harness configuration.

• Disconnect power to the appliance before beginning any repair to avoid shock or injury.
• Verify connector orientations and routing before final assembly; secure harness away from heat and moving parts.
• Use the original mounting clips/retainers or equivalent to prevent chafing; replace damaged clips as needed.