Amana Dryer Parts

• Door won't close

Took off front cover of drier, removed old part and just snapped in new part. Read more

• Shuts off too soon

Replaced heating element about three months ago. Had to order thermistor because of error code "ts" on display and dryer would not run. Removed the two screws on the back that holds the top in place. After removing the top, remove the screws that hold the control panel on front. Make sure not to break the tabs that help hold it in place You do not have to unplug any connectors for the control panel. Lay control panel across top of dryer carefully so that it will be out of the way. Next... Read more

• Takes too long to dry
• Doesn't shut off

Changed Thermistor, Thermostats and the Thermal Fuse Assembly. I did not remove drum, so squeezing my hands in-between drum and vent hose pipe to remove screws was a tight fit, but doable. Read more

Changed the old parts with the new ones. Unscrewed one side. The other side was broken Put the new parts together and screwed back into place Done. Everything works Read more

I took the back cover off the dryer. I changed the heater element, easy fix. Read more

Took a screw driver lifted the top, Unscrewed two screws holding the front on the inside of the dryer one to left and one to the right. Laid the front on the floor and removed to other screws holding the collector in place, popped out old one cleaned all the lint and dust and popped the new one in put the new seal in place and done ! Read more

Replace lint filter and will install cover in a few days. Read more

The cylinder roller that supports the dryer drum was worn and needed to be replaced. I ordered the idler pulley shaft and associated parts as well since I wasn't sure if these were worn too. Watching the video on the web site gave me a good idea what was involved and where to look. It wasn't my exact model and make but provided sufficient information on what to look for. The parts were exact fits which was a great relief abd the dryer is running like new again! Read more

I replaced both the cycling thermostat and the hi limit thermostat along with a new thermal fuse and it seems to have fixed the problem. I thought it might be one of the thermostats but they both had continuity so I decided one of them must be faulty in some way so I just replaced both of them. I was very pleased with the prices and the quick shipping from Appliance Parts Pros. The parts were at my house in only a day and a half from when I ordered them. Read more

First time DIY dryer repair. Videos very helpful! Remove front. Found glides worn thin, paint on drum removed where glides located. Drum, cage and motor turned easily - must be OK. Thirteen year old dryer. Order glides & felt, might as well replace belt and rollers while there. First time order - could not have been easier! Received 2nd day. Replaced parts, reassembled & connected power. Ran for 3 minutes with scraping noise then stopped with burning odor. Disassembled dryer, smelled odor from... Read more