Bosch Dishwasher Parts

The Roller and Cable Assembly is an OEM part for Bosch dishwashers. This assembly includes the roller and cable, which work together to facilitate the smooth operation of the dishwasher door, allowing it to open and close effortlessly.

Over time, the roller and cable can wear out or become damaged due to regular use, friction, or accidental mishandling. If either component fails, it can affect the balance and movement of the dishwasher door, making it difficult to operate.

Symptoms of a bad roller and cable assembly include:

• Difficulty in opening or closing the dishwasher door
• A sagging or misaligned door
• Unusual noises when operating the door
• The door not staying securely in place

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Dishrack Stop Kit is an OEM replacement part for Bosch dishwashers. This kit comes with both the front and the rear stop, these parts are installed at either end of the rails that the upper rack slides on. These stops help keep the rack on the rail, without this part the upper rack of your dishwasher will not slide in and out of your dishwasher properly.

Causes of faulty dishrack stops include wear of sliding surfaces through repetitive racking and unracking over extended use. Exposure to moisture in the wash chamber environment can accelerate degradation.

Symptoms of a bad dishrack stop kit include:

• Dishracks slipping during rotation potentially damage fine china
• Clearance issues where racks impact other interior components
• Potential tipping if stops fail to release rack load onto door interior

This OEM Bosch part is also compatible with Thermador, Gaggenau and some Kenmore models.

The Button is an OEM component specifically designed for select Bosch dishwasher control panels. It initiates cleaning cycles upon end-user selection.

Reinforced polymer caps withstand millions of presses without cracks or splits. Gold-plated contacts provide dependable electrical pathways starting wash sequences. 

Causes requiring replacement commonly relate to prolonged use over decades of wearing through water-resistant barriers. Direct impacts could also unsettle attachment boards necessitating full assembly swapping.

Symptoms  of a bad button include:

• Failure to register selections or improperly engaged cycles  
• Loosened fasteners no longer securely mount interface points
• Cracked or distorted housings exposing internal switch mechanisms

Note: In some cases, the buttons are not all the same and it matters which location/order you put them.

This OEM Bosch replacement button is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers relying on electronically controlled sequences. Proper installation restores intended cycle initiation capabilities.

The Facia Panel is an OEM part for Bosch dishwashers. It's the front interface of the appliance, housing the control buttons and display that allow users to select and monitor wash cycles.

The causes of a bad Facia Panel can be varied. Over time, the panel may exhibit wear and tear, the labels on the buttons can fade, or the buttons themselves can become unresponsive due to frequent use. In some cases, exposure to moisture or an accidental impact can damage the panel, affecting its appearance and functionality.

Symptoms of a bad Facia Panel include:

• Unresponsive buttons
• Faded labels or displays
• Physical damage like cracks or chips
• Difficulty in operating the dishwasher due to malfunctioning controls

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Button is an OEM part for Bosch dishwashers. It serves as a component of the control panel, allowing users to select various wash cycles, options, and settings for operating the dishwasher.

Causes of a malfunctioning Button can include physical damage from impact or excessive force when pressing, as well as general wear and tear over time. 

Symptoms of a bad Button include:

• Unresponsive or stuck buttons, making it difficult to change settings
• Certain dishwasher cycles or options not engaging correctly
• Worn-out or faded button labels or markings, making them hard to read

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The Spray Arm is an OEM part for Bosch dishwashers. It is responsible for evenly distributing water across the dish racks during wash cycles using a rotating arm and nozzle design.

Causes of a bad spray arm can include mineral or limescale buildup that inhibits water pressure/flow, or damage from accidental impact that impacts its rotation. Over time, normal wear and tear on plastic spray arms can also affect optimal spray coverage.

Symptoms of a bad spray arm include:

• Poor or uneven cleaning results
• Dirt or food debris remaining on dishes after cycles complete
• Clogs or blockages in the arm and nozzle openings

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The Cabinet Side Seals are an OEM part for Bosch dishwashers. These seals are located along the sides of the dishwasher cabinet and play a crucial role in preventing water leaks and maintaining an airtight seal during operation.

Causes of a bad seal can include general wear and tear over time, exposure to high temperatures or moisture, or damage from mishandling or improper installation.

Symptoms of a bad Cabinet Side Seal include:

• Water leaks or moisture buildup around the sides of the dishwasher
• Difficulty closing the dishwasher door properly
• Decreased efficiency in drying performance
• Potential for water damage to surrounding areas

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Float Switch is an OEM part for Bosch dishwashers. This part monitors the water level inside the dishwasher. It helps prevent overflows by detecting when the water level gets too high and signaling the control board to stop filling and start draining the water.

Causes of a bad float switch can include wear and tear from regular use, buildup of debris or mineral deposits, or electrical malfunctions.  

Symptoms of a bad float switch include:

• The dishwasher not filling with water
• Water overflowing from the dishwasher
• The dishwasher not advancing through the cycles
• Error codes related to water level issues

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Screw (Toe Kick) is an OEM part for Bosch dishwashers. It is a mounting fastener that secures the toe kick panel to the bottom frame of the appliance. As a low-profile screw, it serves an important aesthetic purpose while maintaining structural integrity.  

Causes of a failed screw can include wear and deterioration from constant vibrations during cycles, or physical damage if the toe kick panel is impacted. 

Symptoms of loose or missing toe kick screws include:

• Sagging or detachment of the toe kick panel from the dishwasher
• Unsightly gaps appearing below the appliance  
• Possible shifting of the entire dishwasher if not properly secured
• Access issues for cleaning beneath the unit

Replacing with this genuine Bosch screw restores proper mounting of the external panels. It is also compatible with some Asko, Thermador, and Jenn-Air specialty dishwashers. 
 

The Control Panel Facia is an OEM replacement part for Bosch built-in dishwashers. As the interface displays cycle selections and status lights, it plays a pivotal role in machine operation.

Causes usually relate to the extended exposure facias endure to environmental conditions and physical contact over years of use. As a high-touch interface, replacement becomes necessary when usability declines to restore optimized functionality.

Symptoms of a compromised control panel facia can include:

• Difficulty distinguishing settings or cycle progress lights
• Loose or unstable mounting allows unwanted movement
• Cracked facia surfaces breaching external barrier protection
• Peeling or flaking overlay defeating clear legibility

This OEM Bosch part is also compatible with Thermador, Gaggenau and some Kenmore models.

The On/Off Switch is an OEM part for Bosch dishwashers. It provides the function of powering the unit on or off with the press of a button.

Causes can be normal wear over thousands of cycles or moisture damage compromising electronics. Physical impact could also affect switch operation over time.

Symptoms of a bad on/off switch include:

• The dishwasher failing to start wash cycles when the switch is engaged
• Washers inadvertently stopping mid-cycle or short cycling irregularly
• The control panel lighting/interface malfunctioning or unresponsive

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This assembly includes the handle. Color: gray. Measures about 5 inches wide by 9 inches high by 9 inches deep.

The Silverware Basket Assembly is an OEM part for Bosch dishwashers. This basket is located in the lower rack and is used to hold utensils securely during the wash cycle.

Causes of a bad silverware basket can include damage from normal wear and tear over time or bending/warping from overload.

Symptoms of a dysfunctional basket include:

• Silverware clustering and not receiving thorough cleaning
• Tines bending or breaking off from the basket
• Dividers popping out of place
• The basket shaking or slipping during the wash cycle

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Color: White

The Leveling Foot is an OEM part for Bosch dishwashers. It is designed to provide stability by allowing you to adjust the height of the dishwasher, ensuring it is level on uneven flooring.

Causes of a bad leveling foot can include wear and tear over time, damage from excessive force or impact, or thread stripping from frequent adjustments.

Symptoms of a bad leveling foot include:

• The dishwasher rocking or wobbling during operation
• Difficulty in achieving a level position
• Increased noise or vibration when the dishwasher is running

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Dispenser Gasket is an OEM part for Bosch dishwashers. This gasket forms a seal around the detergent dispenser, ensuring that water and detergent are properly contained within the dispenser until they are released during the wash cycle. It helps prevent leaks and ensures efficient operation of the dishwasher’s detergent system.

Causes of a bad dispenser gasket can include regular wear and tear, exposure to high temperatures, and the use of harsh detergents. 

Symptoms of a bad dispenser gasket include:

• Leaks around the detergent dispenser area
• Detergent not being dispensed properly
• Visible cracks or wear on the gasket
• Water pooling inside or outside the dispenser

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This kit replaces the sliding rails that support and guide the upper dishrack, restoring smooth, level movement so the rack doesn't bind, tip, or drop during loading and unloading.

• Guides the upper rack in and out along the tub sidewalls
• Helps correct a sticking, uneven, or hard-to-slide upper rack
• Can reduce issues like a sagging rack or difficulty engaging rack stops
• Wear from age, heavy loads, or corrosion can require replacement

• Disconnect power and shut off water before servicing
• Remove the upper rack and stops to access and swap the rails
• Transfer any hardware from the old rails
• Test rack travel and ensure stops are secure before restoring power