Bosch Dishwasher Parts

Hose, with o - ring, shu (uc/12 & above)

This Sump to Float Hose is an OEM part for Bosch Dishwashers. It functions to carry water from the dishwasher sump to the float assembly. Continuous water flow and exposure to detergents can lead to wear or damage over time.

What Causes a Bad Sump to Float Hose:
Exposure to chemicals and hot water, along with wear from water flow, can cause the hose to degrade or develop cracks.

Symptoms of a Bad Sump to Float Hose:

• Water leakage around the dishwasher
• Incomplete or interrupted washing cycles
• Visible cracks or damage to the hose

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This drain hose channels wastewater from your dishwasher to the household drain. Replacing a brittle, cracked, or clogged hose restores proper draining and helps prevent under-sink leaks and water backup. What it does:

• Provides a sealed path for wastewater from the dishwasher's drain outlet to the home's drain system
• Common failure signs include slow or no draining, water left in the tub, or water backing up
• Drips or leaks at hose joints, behind the unit, or under the sink
• Visible kinks, cracks, or deterioration; possible blockage leading to odors or strain on the drain pump

• 1 drain hose

• Disconnect power at the breaker and shut off the water supply; pull the dishwasher forward for access
• Place a towel or pan to catch residual water when removing the old hose
• Reuse existing fittings/clamps; route the new hose with a proper high loop/air gap as required, avoiding sharp bends and kinks
• Run a drain/rinse cycle and inspect all connections for leaks

The Hinge Lever (RH) is an OEM component specifically designed for Bosch dishwashers. This right-hand lever is a part of the dishwasher door hinge assembly, working to open and close the door during each use. 

Causes of a bad hinge lever can include wear and fatigue over thousands of opening and closing cycles. Damage can also potentially occur from any impact or denting of the door surface near the lever mechanism.

Symptoms of an ineffective hinge lever include:

• The dishwasher door sagging or becoming misaligned  
• Difficulty fully opening or closing the door
• Loud squeaks or grinding noises coming from the hinges
• The door potentially detach from the hinge if broken 

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers.

This is a button. This is a genuine OEM part made by Bosch and has been sourced directly from the manufacturer. This part is intended to replace a broken or defective button on certain different makes and models of dishwashers.This button attaches to the front panel of the dishwasher and is needed for powering on and off the dishwasher. Over time and with regular use, buttons can become worn or broken and stop working. This part requires proper tools for replacement. Before starting, disconnect the dishwasher completely from both power and water hookups. Please follow appropriate safety precautions when attempting to repair any appliances. For more accurate information on how and where to install this button, the appropriate owner's manual and included diagrams should be referred to.As an authentic replacement part, this button is suitable for use on several different models of dishwashers manufactured by Bosch, Thermador, and Gaggenau. Please note that this is a genuine part made of high-quality, durable materials and is sold individually.

This start button is the user-pressed cap on the control panel that engages the underlying switch to begin a cycle. Replace it to restore proper feel and reliable operation when the original button is cracked, loose, or missing.

• Serves as the Start control on the user interface
• Transfers your press to the control's start switch to initiate a cycle
• Helps address a broken, sticking, or missing start key
• Restores alignment and tactile feedback at the control panel

• Disconnect power to the appliance before servicing.
• Open or remove the control panel/fascia to access the button.
• Release retaining tabs/clips and remove the old button; transfer any small clips/springs from the original if present.
• Align and snap the new button into place, reassemble, and test operation.

The Lower Spray Arm is an OEM part for Bosch dishwashers. This part is responsible for spraying water and detergent solution onto the dishes during the wash cycle, ensuring thorough cleaning.

Causes of a malfunctioning Lower Spray Arm can include clogging or obstruction from food debris, mineral buildup, or foreign objects.  

Symptoms of a bad Lower Spray Arm include:

• Poor cleaning performance, with dishes coming out dirty or with food particles remaining
• Water not spraying evenly or failing to rotate during the wash cycle
• Loud grinding or knocking noises coming from the spray arm area

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The Sealing is an OEM replacement part for Bosch brand dishwashers. Located on the perimeter of the small rinse aid compartment door, this resilient rubber piece forms an essential water-tight seal when the dispenser is closed.   

Symptoms of a potentially problematic rinse aid door sealing include:

• Leakage or spills within the rinse aid reservoir
• Mineral deposits or residue build up inside the compartment  
• Cracks, tears, or deformation of the sealing material

Causes of a faulty rinse aid door sealing can be repetitive opening/closing stress breaking down pliability long-term. Exposure to chemical vapors from the rinse aid may also degrade sealing properties.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Door Pulley Rope is an OEM part for Bosch dishwashers. It works with the door latch mechanism, allowing smooth opening and closing of the dishwasher door. 

Causes of a bad door pulley rope can include fraying or breakage due to repeated use over time. Exposure to heat and chemicals may also damage synthetic fibers prematurely. 

Symptoms of a bad dishwasher door pulley rope include:

• Difficulty latching or sealing the dishwasher door 
• Sliding or squeaking noises coming from the door 
• The door not sitting flush or properly aligned
• The door is unable to stay fully open for loading/unloading

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Dishwasher Control Panel Facia is an OEM replacement part designed specifically for Bosch dishwashers. It serves as the interface to control all wash cycles and provides informative displays. Causes of a damaged control panel facia can be general wear and tear over time. 

Symptoms of a bad control panel facia include:

• Non-responsive buttons
• Cracked or broken surfaces
• Controls that do not align properly

This genuine Bosch facia restores the correct function and appearance of the control panel. This Bosch part can also be used on Thermador and Gaggenau appliances.

This push button set replaces the plastic buttons on the control panel, restoring clean looks and reliable, consistent presses so you can select settings and operate the unit without dealing with sticky, cracked, or missing buttons. What it does:

• Provides the physical button caps that interface with the control board's switches
• Restores proper button travel and tactile feel
• Helps when buttons are loose, stuck, cracked, missing, or difficult to press
• Refreshes worn, faded, or damaged button faces for a cleaner appearance

• One set of control panel button caps

• Disconnect power before servicing
• Access the control panel/fascia to reach the button area
• Remove the old button set; align and seat the new set so actuators engage the switches
• Reassemble and test each button for smooth operation

The Hinge Lever (LH) is an OEM part for Bosch dishwashers. This left-hand lever is responsible for assisting in the opening and closing of the dishwasher door through a pivoting motion. The hinge lever works with other door components like springs and cables to provide smooth, balanced movement of the door. 

Symptoms of a bad Hinge Lever include: 

• Difficulty opening or closing the dishwasher door  
• The door not staying securely closed during the cycle
• Excessive noise or creaking coming from the door area
• Misalignment of the door 

Causes of a bad Hinge Lever can include normal wear and tear over time, damage from excessive force or weight on the door, or loose mounting hardware.

Note: Left hinge lever

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
 

NTC (negative temperature coefficient). Resistance or capacitance decreases when temperature increases.

The Temperature Sensor with Hi Limit Thermistor is an OEM part for Bosch dishwashers. This sensor monitors internal temperatures, providing feedback to the control module during each cycle.

Causes of failure can be related to mineral buildup over time interfering with sensing or physical damage to wiring or connectors.

Symptoms of a bad temperature sensor include:

• Abnormal or inconsistent wash temperatures
• Error codes related to temperature issues
• Reduced cleaning performance from improper heating

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

The Sensor is an OEM replacement part for Bosch dishwashers. It detects soil levels through cycles, automatically adjusting water volumes and times for optimal cleaning. Precise sensing reduces overwashing.

Causes of a bad sensor involve general deterioration from continuous usage monitoring wash parameters thousands of times. Dirt or debris accumulation triggers false readings, decreasing efficiency.

Symptoms of a bad sensor include:

• Extended cycle times as improper inputs cause system delays  
• Inconsistent wash results relying on default static cycle settings
• Error codes displayed indicating disrupted functionality
• Soiled dishes from inadequate adjustments meant for heavier loads 

This OEM Bosch part maintains customized cleaning for Thermador versions as well.

The Filter-Micro is an OEM part for Bosch dishwashers. This filter plays a critical role in trapping food particles and debris during the wash cycle, preventing them from recirculating and ensuring that the water used for cleaning is as clean as possible. By maintaining proper filtration, it helps improve the dishwasher’s cleaning performance and extends the life of the pump and other components.

Over time, the filter can become clogged with food particles, grease, or mineral deposits, which may reduce its effectiveness. Regular cleaning can extend its life, but eventually, it may need to be replaced if it shows signs of wear or damage.

Symptoms of a bad filter include:

• Poor cleaning results
• Water drainage issues
• Strange noises during operation
• Dishes remaining dirty after a wash cycle

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers.

The Panel Facia is an OEM part for Bosch dishwashers. It is responsible for covering the front interior panel and electrical components of the dishwasher. The panel facia plays an important protective and aesthetic role.

Causes of a bad panel facia can include damage from harsh cleaning chemicals, cracks or breaks from impact, or signs of normal wear and tear over time. 

Symptoms of a bad panel facia include:

• Cracks, broken pieces, or warped panels
• Troubles with buttons not responding properly  
• Exposure to electrical wiring
• Deterioration of surface finishes

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
 

The Panel-Facia is an OEM part for Bosch dishwashers. As the front panel interface, it houses all control buttons, displays, and status indicators.

Symptoms of a bad panel-facia can include non-responsive or stuck buttons, indecipherable displays, or cracks that compromise the panel's integrity. 

Causes of a bad panel-facia dishwasher include:

• Unresponsive or inaccurate control buttons
• Fault codes that cannot be cleared  
• Cracked or damaged fascia compromising controls
• Disrupted electronic communication preventing cycles

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.