Need Help?
Call or text
Replacement rail for dishwasher upper dishrack. Installs inside tub to guide rack sliding. Replace if cracked, bent, or causing rack to fall off track.
Replaced four rollers & slide. Read more
Stabilizes the washer tub during spin cycles. Replace worn or broken rear shock absorbers to restore smooth operation and prevent drum contact with cabinet.
Replaced pump. All components are accessible from the front of the machine. You have to remove two screws in the back that hold on the top cover, then slide the cover back. This will allow access to the screws that hold on the control panel. Remove the control panel (unplug cable), then remove the spring/wire that holds on the door bellows to the front panel (removing and installing that is the most difficult part of the job) and carefully remove the bellows from the front panel. Then remove... Read more
Front shock absorber kit stabilizes the washer tub during spin cycles. Replace worn, loose, or broken dampers to restore smooth operation and stability.
I tore it apart using. YouTube videos to guide me and found the shocks were loose and floppy. I found the shocks in stock here and had them in my hand 2 days later for only $10 shipping! It runs great now! Read more
Set of 4 suspension rods that support and steady the wash tub. Replace if rods are worn, broken, or causing excessive vibration during the spin cycle.
I ordered a tub suspendion Kit for it. Read more
Secures the spray arm to the dishwasher rack, allowing proper rotation during wash cycles. Replace if cracked, broken, or missing to restore spray arm.
We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more
Covers and protects the dishwasher pump assembly. Replace if cracked, broken, or if plastic guides are stripped causing spray arm support issues.
The cover was easy to remove with 3 star head screws. I entered my model number on AppliancePartsPros.com dreading the cost I was about the encounter. However, the parts were very cheap, in stock, and shipped within an hour of my order. I had a question about the tracking number and received an email back in less than an hour. The cost for both parts and standard shipping was under $30. Once I received the parts, the new cover was installed, the rest of the assembly was put back back... Read more
Secures the washer's inner basket to the drive hub, keeping the tub centered and stable during spin. Replace if cracked, corroded, or bolts are damaged.
The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more
Secures the dishwasher's water inlet tube in position, preventing movement and strain on fittings. Replace if cracked, broken, or missing to restore support.
Mounts the lower spray arm assembly to the pump housing in your dishwasher. Replace if cracked, broken, or worn to restore proper spray arm installation.
Ordered parts from appliance pro and installed was a easy repair saved service call no tolls was neede Read more
Includes suspension pads.
Secures upper or lower dishrack to dishwasher frame. Replace if bracket is cracked, broken, or missing to restore proper rack alignment and support.
Secures the upper wash manifold in your dishwasher. Replace this clip if it's cracked, broken, or missing to properly mount the spray arm assembly.
Usually ships within 4 - 14 days
Structural support plate that holds and stabilizes range components to maintain alignment. Replace if cracked, broken, or worn to restore stability.