Dryer Duct Parts

Molded elbow connector that redirects dryer vent hose routing at an angle. Replace if cracked, broken, or missing to restore proper airflow alignment.

90-degree elbow fitting for dryer vent connections in tight spaces. Replace if cracked, broken, or missing to properly route exhaust near walls.

This blower housing encloses the dryer's blower wheel and routes air from the drum through the lint system to the exhaust. Replacing a cracked or warped housing restores proper airflow, reduces vibration, and helps resolve extended dry times.

• Encloses and supports the blower wheel while channeling intake and exhaust airflow
• Helps maintain consistent drying performance and temperature regulation
• Typical failure symptoms: longer cycles, weak vent airflow, excess lint inside the cabinet, scraping or rattling near the blower
• Visual clues: cracks, broken mounting tabs, or housing out-of-round causing wheel contact

• Disconnect power; for gas units, also shut off the gas supply
• Access from the front: remove front panel and lint duct to reach the blower assembly
• Transfer the blower wheel, gasket/seals, and mounting hardware from the original housing as needed
• Seat the housing squarely; the blower wheel spins freely and clear lint buildup before reassembly

Side vent kit for dryers with exterior vent trim and mounting interface. Replaces damaged, missing, or worn vent trim to restore side vent openings.

Factory vent hose assembly for dryers. Installs between drum and exhaust port. Replace when hose is cracked, torn, disconnected, or missing.

Steam hose kit connects water source to dryer steam system. Includes rubber fill hoses and Y connector. Replace if hoses are cracked or leaking.

Right-angle wall elbow redirects your dryer vent through wall openings. Replace worn, damaged, or misaligned elbows to maintain secure exhaust alignment.

Replace your damaged or worn dryer vent hose. This 5-foot flexible duct connects your dryer to the exterior vent, ensuring proper airflow and safety.

Duct hose that connects your dryer's blower to the exhaust vent. Replace if cracked, torn, or disconnected to restore proper airflow and ventilation.

Molded elbow connector that redirects dryer exhaust to your home vent duct. Replace if cracked, loose, or leaking to restore a secure connection.

Adjustable periscope vent for dryers with limited clearance. Installs between dryer exhaust and wall port. Replace if cracked, damaged, or missing.

Adjustable periscope vent for tight dryer installations. Extends 18-29 inches to connect 4-inch dryer vent to wall exhaust in close quarters.

Exterior vent hood for dryer exhaust systems. Replaces cracked, broken, or missing vent covers. Installs at outdoor vent exit point.

8-foot flexible exhaust hose that channels airflow from your dryer to the exterior vent. Replace if torn, kinked, crushed, or clogged with lint buildup.

This duct assembly channels exhaust from the appliance to the home vent, restoring proper airflow and helping reduce lint and moisture buildup. It's a direct-fit replacement for the original ducting on compatible LG units. What it does:

• Directs heated air and moisture from the appliance to the exterior vent
• Replaces damaged, crushed or disconnected ductwork that can restrict airflow
• Helps reduce lint accumulation in the cabinet/vent path when installed and maintained
• Restores a sealed connection between the appliance outlet and household venting

• Disconnect power and unplug the appliance before beginning any repair
• Follow for disassembly and routing; use proper clamps or screws to secure connections
• Inspect connected gaskets, clamps and the external vent path; replace or clean as needed
• Do not operate the appliance with obstructed or damaged venting; clean lint regularly to reduce fire risk