Dryer Knob, Dial & Button

This control knob replaces a cracked, worn or missing front control knob to restore reliable selection of settings and improve safe operation. Designed for direct-fit replacement on compatible Whirlpool appliances. What it does:

• Allows you to turn and select heat, cycle or function settings easily
• Replaces broken, melted or stripped knobs that are hard to grip or won't stay set
• Restores precise user control for safe, consistent operation
• Helps prevent accidental changes caused by damaged controls

• One replacement control knob

• Generally installs by pulling the old knob straight off the control shaft and pushing the new knob onto the shaft until seated
• Disconnect power to the appliance or ensure controls are off before servicing
• If the knob does not fit or operate smoothly, stop and verify shaft type

This small retaining ring secures internal components in place to maintain proper alignment and motion. It helps prevent parts from slipping or shifting, reducing noise and wear for reliable appliance operation. What it does:

• Holds shafts, bearings or assemblies in position to prevent movement
• Stops components from slipping under load or vibration
• Helps reduce rubbing, grinding or rattling noises caused by loose parts
• Maintains proper clearances for smooth mechanical operation

• One retaining ring

• Disconnect power (and water, if applicable) before starting repairs
• Use proper snap-ring/retaining tools to remove and install without damage
• Inspect mating components for wear or damage and replace if necessary

This replacement bezel restores the control panel trim for a smooth, finished look and helps protect the console area from spills and wear. It's a direct-fit cosmetic and protective piece for the appliance control area. What it does:

• Covers and protects the control panel surface and underlying components from spills and damage
• Provides the finished trim that secures buttons, dials, or the display area
• Replaces cracked, warped, or cosmetically damaged trim that can catch debris or impede controls
• Helps keep the control area sealed and easier to clean

• Disconnect power to the appliance before starting any repairs to avoid shock or injury
• Typical installation requires removing a few screws or clips on the control console; keep fasteners for reassembly
• Handle painted or plastic surfaces carefully to avoid scratching; use a soft, non-marring tool to pry clips if needed

A single push-button power control that replaces a worn or damaged front-panel power button, restoring reliable on/off control and user input for the appliance's control panel. What it does:

• Provides the tactile push control used to turn power on/off or wake the control board
• Restores a missing, cracked, or unresponsive power switch on the appliance control panel
• Helps resolve intermittent or non-responsive power-button presses when the button itself is faulty
• Works as the user-actuated interface between your touch/press and the control electronics

• High-level replacement; remove power to the appliance before accessing the control panel
• Handle the control panel and button carefully to avoid cracking or damaging trim pieces
• If the button is part of a switch or membrane assembly, verify the full assembly condition before replacing only the button

This bezel is the decorative trim that surrounds the appliance control panel, restoring a clean, finished look and protecting the underlying controls from dust and debris. It helps maintain the appliance's appearance and user access. What it does:

• Covers and protects the control area while providing a finished appearance
• Helps keep dust, grease, and moisture away from buttons and displays
• Restores a loose, cracked, or faded trim to improve usability and aesthetics
• Matches the original mounting points for straightforward alignment

• One bezel

• Remove power to the appliance before beginning any work to avoid electrical shock
• Installation typically requires removing the control panel screws or clips; keep fasteners for reassembly
• Handle carefully to avoid scratching the finish or damaging retention tabs
• If any clips or screws are broken, replace them before reinstalling the bezel