Electrolux Washer Parts

Fix a washer that won't start or run because the door won't lock. This door lock assembly secures the door during wash cycles. DIY-friendly repair.

Secures internal washer components during transport to prevent damage from movement. Includes brackets and bolts needed when relocating your machine.

Plastic door cover

This small cup fits inside the washer's dispenser drawer and holds liquid detergent, releasing it into the wash drum at the appropriate time during the cycle. It is designed to meter out the correct amount of detergent for optimal cleaning. Replace if the cup is cracked, warped, or missing, or if detergent is not dispensing properly during the wash cycle.

This is a small C-clip or retainer ring that secures the idler pulley to its bracket on a laundry center. It keeps the pulley in place so the drive belt maintains proper tension against the drum. Replace this ring if the idler pulley has come loose, the drum belt slips or falls off, or the dryer drum does not spin properly.

Rubber bumper cushions washer lid closure. Installs between lid and cabinet to absorb impact and reduce noise. Replace if worn, cracked, or missing.

Trunnion assembly for washing machines. Supports and allows outer tub rotation during wash and spin cycles. Replace if cracked, worn, or damaged.

Rubber grommet cushion for laundry center washers. Isolates vibration and prevents wear where components pass through openings. Replaces worn or missing.

This is a rubber hose that connects the detergent or fabric softener dispenser to the wash tub, allowing dispensed products to flow into the drum during the wash cycle. Over time this hose can crack, clog, or develop leaks. Replace it if you notice detergent not reaching the tub, water leaking near the dispenser area, or visible deterioration of the hose.

Rubber O-ring seal prevents water leaks at hose connections and fittings. Replace when worn or cracked to restore tight seal and stop dripping. Verify fit.

Secures hoses to fittings, preventing leaks in water and drain lines. Replace when connections loosen or leaks appear. Verify fit with your model number.

Replace your washer's cracked or missing access cover. Restores exterior protection, shields internal components from dust and moisture, and provides a clean finished appearance.

This is a replacement push button that fits on the appliance control panel and restores tactile control for a single function. It provides a simple, direct way to replace a worn, loose, or missing button so controls are usable again. What it does

• Replaces a damaged, cracked, or missing control panel push button
• Restores a firm tactile surface for reliable pressing of a single function
• Helps stop intermittent or unregistered button presses caused by wear
• Keeps the control panel looking complete and prevents accidental contact with underlying switches

• One push button

• Disconnect power to the appliance before any service to avoid shock or injury
• Typically snaps into the front of the control panel or slides onto a stem; keep track of orientation
• If access requires removing the control panel, keep screws and small parts organized for reassembly

Cushion bumper for washer installation. Absorbs vibration and protects cabinet surfaces. Replace if cracked, compressed, or missing to restore proper support.

Secures hoses on your washer to prevent leaks and water damage. Replace if loose, cracked, or during hose repairs. Verify fit with your model number.