Frigidaire Dishwasher Duct Parts

The Vent Blower Assembly is an OEM part for Frigidaire dishwashers. It is designed to help ventilate the dishwasher by expelling hot, moist air from the interior after the washing cycle. 

You should replace the vent blower assembly if it becomes faulty. Causes of a bad vent blower assembly can include regular wear and tear, blockages from debris, or electrical issues. A malfunctioning vent blower can lead to poor drying performance and excessive moisture inside the dishwasher.

Symptoms of a bad vent blower assembly include:

• Dishes not drying properly after the wash cycle
• Excessive moisture or condensation inside the dishwasher
• Unusual noises coming from the vent blower area
• The dishwasher emitting warm, moist air less effectively

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

This air brake/drain hose assembly creates an anti-siphon break in the drain line and safely routes wastewater to household plumbing. Replacing a cracked, kinked, or clogged assembly restores reliable draining and helps prevent leaks or backflow.

• Provides the air gap/vacuum break to help prevent siphoning and contamination
• Connects the dishwasher's drain outlet to the air gap or garbage disposal/inlet
• Helps keep water from backing into the tub after a cycle
• Typical failure signs: leaks, slow or no drain, water returning to tub, visible hose damage

• Disconnect power; shut off water supply and place towels to catch residual water
• Note original hose routing and clamp positions; reuse existing clamps and seals as needed
• Maintain a high loop or external air gap per local code when routing the drain line
• After installation, run a short cycle and inspect all connections for leaks or kinks

This duct assembly channels air through the appliance to maintain proper airflow and reliable operation. Replacing a damaged or cracked duct helps restore ventilation and can reduce noise and poor performance. What it does:

• Directs air from the blower/tub area into the vent path to enable normal airflow
• Prevents leaks that can reduce drying/cooling efficiency or cause longer cycles
• Helps reduce vibration and rattling caused by a loose or broken duct
• Common symptom: reduced airflow, longer cycle times, or unusual noise during operation

• Disconnect power to the appliance before beginning any repair
• Inspect surrounding seals and mounting tabs; replace any damaged hardware
• Basic hand tools required; handle carefully to avoid cracking plastic tabs

A replacement vent assembly that directs airflow inside the appliance to restore proper circulation and temperature control. Installs behind access panels to replace a damaged or cracked duct and help the appliance run more efficiently. What it does

• Channels conditioned or exhaust air between components to maintain correct airflow paths.
• Helps prevent air leaks that can cause uneven cooling or longer run cycles.
• Commonly replaced when the duct is cracked, broken, or obstructed.
• Reduces noise caused by loose or damaged vent components.

• Vent assembly (1)

• Disconnect power to the appliance before starting any repair.
• Access may require removing exterior or interior panels; keep fasteners organized for reassembly.
• Align tabs and gaskets during install to ensure a proper seal; do not force parts.

This vent assembly directs refrigerated air from the evaporator into the fresh-food compartment to help maintain even cooling and airflow. It restores proper air distribution and reduces temperature variation in the refrigerator interior. What it does

• Channels cold air from the evaporator into the fresh-food section for balanced temperature distribution.
• Helps eliminate warm spots and uneven cooling that can cause food to spoil prematurely.
• Reduces airflow noise caused by damaged or misaligned vent components.
• Works with the fridge's air control system to support consistent compartment temperatures.

• Disconnect power to the appliance before beginning any repair.
• Remove interior liners or shelves as needed to access the vent location; use basic hand tools.
• Inspect surrounding seals and mounting tabs during installation; replace if damaged.