Frigidaire Range Screws, Nuts, Washers

Compression nut secures the pilot assembly on gas range burners. Replace if stripped, corroded, or missing to properly fasten pilot tube connections.

This is a replacement hex nut used to secure appliance components and fasteners. It restores proper fastening where a lost or damaged nut causes loose panels or hardware and helps stop rattling or movement. What it does

• Secures panels, brackets, or components to threaded studs or bolts
• Restores proper tension where a missing or stripped nut allows parts to wobble
• Helps eliminate noise from loose hardware and prevents further wear
• Used wherever a matching-thread nut is specified by the manufacturer

• Confirm thread size and type match the original before installing
• Hand-thread first to avoid cross-threading, then tighten with appropriate tool
• Wear eye protection and disconnect power to appliance if working near electrical components
• Do not overtighten; replace any damaged studs or bolts rather than forcing this nut

Decorative nut for gas range exterior trim. Secures cosmetic panels and trim pieces. Replace if lost, stripped, or corroded for a clean finish.

Secure dishwasher components with this #8 x 5/8" mounting screw. Replace lost, stripped, or corroded screws to properly fasten panels and parts.

This replacement mounting screw secures panels and components in compatible Frigidaire appliances, helping restore stable assembly and safe operation. It's a direct-fit fastener used where the original screw has been lost or damaged. What it does

• Fastens appliance panels, brackets, and small parts to restore secure assembly
• Replaces stripped, rusted, or missing screws that can cause rattling or loose components
• Matches the OEM fit for reliable retention and alignment during normal use

• Use the correct size driver to avoid stripping the head; tighten until snug but do not overtighten
• Disconnect power or follow appliance-specific safety procedures if working near electrical components
• Inspect surrounding hardware and replace as needed

A single replacement mounting screw that secures the transformer to the appliance chassis. Keeps the transformer firmly attached to help maintain reliable power to the controls and reduce vibration-related noise. What it does:

• Secures the control/door transformer to the appliance chassis or bracket.
• Prevents transformer movement that can cause rattling or vibration noise.
• Helps maintain proper electrical connections by keeping the transformer stable.
• A missing or loose screw can lead to intermittent power to controls or unusual sounds.

• Always disconnect power to the appliance before starting work.
• Use the correct screwdriver to avoid stripping the head; tighten snugly but do not overtighten.
• Keep original hardware and screw length and thread match before installing.
• If the transformer or wiring looks damaged, replace or inspect components as needed before reassembly.

This flat washer is a replacement fastener spacer that helps secure and evenly distribute load on screws or bolts in your appliance. Installing the correct washer restores proper fastening and prevents metal-on-metal wear. What it does:

• Provides an even bearing surface under a screw or nut to secure assemblies
• Helps maintain proper alignment of parts and prevents loosening from vibration
• Reduces wear and protects mating surfaces from damage
• Commonly used where a thin, flat spacer is required during reassembly

• One flat washer (quantity: 1)

• Turn off and unplug the appliance before starting any repair
• Replace only the washer(s) that match the original location and orientation
• Hand-start fasteners to avoid cross-threading; tighten to OEM torque if specified
• If the original washer shows damage or corrosion, replace it with this new part