Frigidaire Range Support Parts

Replace your oven's support plate if it's cracked, broken, or missing. This structural component mounts inside the oven cavity to secure internal parts.

Secures the rear control panel to your oven for a stable, flush fit. Replace if the original bracket is bent, broken, or missing to eliminate panel movement.

Left-side backguard support bracket secures the backguard to your oven frame. Replace if bracket is cracked, broken, or missing to restore stability.

Mounting plate that secures the oven to the cabinet or wall. Replace this metal support plate if it's bent, rusted, or missing to ensure proper installation.

Support plate for range spice rack. Mounts inside the range to secure the spice rack assembly. Replace if cracked, broken, or missing for proper support.

Reflector plate for ranges. Installs beneath burners to direct heat and protect components. Replace if cracked, warped, discolored, or missing.

This instrument mounting plate secures the appliance control or instrument cluster inside the cabinet, keeping electronic components aligned and stable for reliable operation. It helps restore proper fit and prevents movement that can cause noise or poor connections. What it does:

• Provides a firm mounting surface for the control board or instrument cluster
• Keeps connectors and wires properly positioned to maintain electrical connections
• Reduces vibration and rattling from loose or damaged mounting points
• Restores alignment so buttons, displays, and knobs operate correctly

• One instrument mounting plate

• Disconnect power before starting any repair to avoid electrical shock
• Retain or reuse original screws unless replacements are specified; verify screw sizes before installation
• Handle edges carefully; mounting plates may have sharp edges
• Check alignment and connector seating before reassembling the cabinet panels

Support plate that secures the burner tube assembly in your range. Replace if cracked, warped, or corroded to properly mount and stabilize burner components.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

This channel burner support is a stamped support bracket designed to hold and align the range burner channel and related components so burners sit correctly. It helps restore proper fit and stable burner operation. What it does:

• Secures the burner channel and keeps burners aligned for consistent heating
• Prevents wobbling or misalignment of the burner assembly during use
• Helps maintain correct spacing between burner components and gas valve/manifold
• Commonly replaced when the original support is bent, cracked, or damaged

• One channel burner support bracket

• Designed to mount with existing fasteners; inspect screws or clips and replace if worn
• Turn off power and gas supply (for gas ranges) before servicing; follow appliance safety procedures
• Handle sharp edges carefully; wear gloves to avoid cuts