General Electric Cooktop Gasket & Seal

Seals the valve assembly on your cooktop to prevent gas leaks. Replace if you notice gas odor or poor burner performance. Confirm fit with your model.

This seal manifold is the molded gasket that seals the connection between the manifold and valve assembly, preventing leaks and ensuring proper flow. It restores a watertight/gas-tight seal where the manifold meets the control valves. What it does

• Seals the joint between the manifold and valve assembly to prevent fluid or gas leaks.
• Helps maintain correct pressure and flow through the manifold and valves.
• Addresses symptoms such as visible leaks, strong odors, or intermittent flow/operation around the manifold area.
• Restores reliable sealing after manifold or valve service or when the original seal is damaged.

• Before you start, disconnect power and shut off water or gas supply as applicable to the appliance.
• Replace only with the matching OEM part and ensure mating surfaces are clean and dry for a proper seal.
• Tighten manifold fasteners evenly to the manufacturer's guidance to avoid distortion (follow OEM torque/sequence if available).

Seals the burner box to prevent gas leaks and ensure safe operation. Replace if worn, cracked, or damaged to maintain proper seal. Verify fit with your model.

Foam gasket tape seals gaps around cooktop burners and edges to prevent spills from leaking beneath. Replace if worn, compressed, or damaged. Verify fit with your model number before ordering.

This adhesive foam tape provides a soft, compressible seal that cushions and helps block drafts, moisture, and vibration around appliance panels and components. It restores a tight fit and reduces noise where panels meet. What it does:

• Creates a compressible seal to reduce air drafts and help limit moisture intrusion
• Cushions panels and components to reduce vibration and rattling noise
• Fills small gaps to improve fit between trim, doors, or housings
• Sticks to clean, dry surfaces for easy placement and long-lasting hold

• Clean and dry the mounting surface; remove old adhesive before applying
• Cut to fit with scissors; press firmly along the length to ensure good adhesion
• Use gloves if desired; avoid contact with skin or eyes from adhesive residue