General Electric Cooktop Parts

Includes 12 screws.

Specs: 8-32 MCH PNT15

High-voltage wire harness connects power components in your range. Replace if wires are burned, damaged, or failing continuity tests. Restores safe operation.

Replacement wire harness for gas cooktop burners. Restores electrical connections between igniter and spark module. Needed when wiring is damaged or worn.

This is a gas burner valve used on a gas range or cooktop to control the flow of gas to a surface burner. Turning the corresponding knob opens or closes this valve to regulate flame height. Replace this valve if the burner won't ignite, the flame cannot be adjusted properly, you smell gas when the knob is in the off position, or the burner flame is uneven.

Fix burner flow issues, gas leaks, or uneven flames with this cooktop valve kit. Direct-fit assembly restores proper gas control. Moderate DIY repair.

This tube routes water from the refrigerator's water valve to the dispenser or ice system, restoring proper water flow and stopping leaks when a cracked or clogged supply tube is the issue. Easy direct replacement for affected lines. What it does

• Carries water from the valve to the dispenser or ice maker so the appliance can fill and dispense properly.
• Commonly replaced when you see leaks at fittings, a puddle under the fridge, or a visibly cracked or split tube.
• Can restore normal water flow when the line is pinched, kinked, or partially obstructed.
• Works with factory fittings and clamps used on the valve-to-ice maker/dispenser connection.

• Turn off the refrigerator's water supply and unplug the appliance before starting; drain remaining water from the line.
• Inspect fittings for damage; loosen or remove existing clamps/fittings to swap the tube, then secure new tube and clamps to prevent leaks.
• After installation, restore water and power, check all connections for leaks, and run the dispenser/ice maker briefly to confirm proper flow.

If your gas cooktop burner won't light or clicks continuously, this igniter electrode creates the spark to ignite the gas. Easy DIY repair in 15 minutes.

Replace your dull, broken, or missing cooktop scraper blade. This cleaning tool blade removes baked-on food and residue from glass cooktop surfaces.

Fix a burner that won't spark or requires a lighter to ignite. This cooktop igniter restores automatic ignition to surface burners. Takes 30 minutes.

This flat washer (.250 inch inner diameter x .812 inch outer diameter) is a simple replacement part that helps distribute load from a fastener and protects mating surfaces for reliable appliance operation. What it does:

• Provides a stable bearing surface for screws, bolts or studs to reduce wear on parts
• Helps distribute clamping force to prevent pull-through or deformation of softer materials
• Reduces vibration and movement at the joint when installed correctly
• Missing or damaged washers can lead to loose fasteners, increased vibration or component misalignment

• Disconnect power and water before servicing the appliance
• Replace like-for-like: inner/outer diameters and thickness match the original washer
• Inspect mating hardware and surfaces for damage; replace corroded or deformed fasteners as needed
• Tighten fasteners evenly and avoid over-torquing to prevent washer or component damage

Natural gas orifice spud for cooktop burner assembly. Needed when converting from LP to natural gas or replacing damaged orifice threading.

Natural gas burner orifice spud for gas ranges and cooktops. Replace when converting from propane to natural gas, or if orifice is worn or damaged.

Protective cover that slips over the gas valve shaft to shield valve components from spills, food debris, and moisture. Replace if cracked or missing.

Burner not heating or won't turn on? This 12-inch halogen element restores radiant heat to your cooktop. Common DIY repair with basic tools in 30 minutes.

Color: black. Measures about 2 inches in diameter.