General Electric Dishwasher Parts

This hex washer-head screw is used in dishwashers to secure panels, brackets, and other hardware. Replacing a missing or corroded fastener restores a tight, stable installation and helps stop looseness or vibration during cycles.

• Fastens dishwasher panels, brackets, trim, or mounts to the cabinet/frame
• Replaces lost or stripped hardware after service or installation
• Helps address loose or rattling panels and minor misalignment
• Stainless steel construction per OEM spec for moisture-prone environments

• Disconnect power and water supply before servicing the dishwasher
• Wear gloves; sheet metal edges can be sharp
• Start threads by hand to avoid cross-threading; tighten with an appropriate driver
• Do not overtighten, especially when threading into plastic

Replace your dishwasher's worn, cracked, or missing timer control knob. Installs on the timer shaft to restore manual cycle selection and dial control.

Replace your dishwasher's lower rack wheel if it's cracked, broken, or worn. This roller ensures smooth gliding of the bottom rack during loading and unloading.

Replacement touch pad with control panel buttons for your dishwasher. Installs on the door exterior. Needed when buttons are unresponsive or damaged.

C-clip retainers secure components in your dishwasher or range. Replace when clips are loose, broken, or missing to prevent rattling and parts shifting. Verify fit with your model number.

Hex washer head screw secures panels, brackets, and shields inside your appliance. Replace missing, stripped, or corroded fasteners for proper fit.

Size: 8-32 x 5/16 inch.

Thread-forming screw secures dishwasher panels, brackets, and trim components. Replace missing or stripped fasteners to restore proper mounting.

Replacement bracket that secures the flood switch in your dishwasher. Holds the leak detection switch in proper position. Needed when bracket is cracked or broken.

Fix dishwasher buttons that won't respond or cycles that won't start with this push button switch. Direct replacement for worn control panel buttons.

Secures hose connections to prevent leaks in your dishwasher. Replace if water pools under the unit or connections feel loose. Confirm fit with your model.

This dishwasher screw secures internal components and panels within your dishwasher's assembly. It provides proper fastening for pumps, motors, and housing components that keep the unit operating smoothly. Replace this screw if internal parts are loose, vibrating excessively, or if the original screw is damaged or missing.

Lower rack roller and stud assembly for dishwashers. Mounts to the bottom rack to allow smooth sliding in and out. Replace if broken, cracked, or missing.

Left-hand door hinge assembly for dishwashers. Installs on the left side to support and secure the door to the cabinet. Replace if bent, broken, or worn.

This is a combined motor and circulation pump assembly that drives water through the spray arms during the wash and rinse cycles. It is the main component responsible for recirculating water throughout the dishwasher tub. Replace this assembly if your dishwasher is not spraying water, making unusual humming or grinding noises, or failing to clean dishes properly.

Fix dishwasher not draining or cleaning issues with this pump and motor assembly. Resolves loud grinding noises and poor water circulation problems.