General Electric Dryer Cap Or Cover

This reversible door plug fills the unused mounting hole when you switch the door swing on your refrigerator. It restores a finished appearance and helps keep air and moisture from entering through the opening.

• Covers the unused door hole created during a door swing reversal
• Helps maintain proper sealing and resists drafts/condensation at the opening
• Restores a clean, finished, factory look to the door
• Common symptoms: missing or cracked plug, exposed hole, cosmetic gap on door edge

• Disconnect power before servicing any door components
• Gently pry out the old plug with a plastic trim tool to avoid scratches
• Align the new plug with the opening and press until fully seated and flush
• Verify the door closes properly and the gasket seals evenly

The Inner Door Cap is an OEM part for GE electric dryers. Located inside the dryer door opening, it functions as the interior lining that shields insulation material. 

GE dryers incorporate insulation around the door area to limit heat loss during cycles. The plastic cap acts as an additional barrier behind the metal door. This maximizes efficiency by retaining warm air circulation only inside the drum. 

Causes of a damaged cap include prolonged heat exposure leaving it brittle with use over time or physical stresses cracking the plastic.

Symptoms of a failed cap include:

• Drafts noticeable near the door seal   
• Reduced internal air temperatures requiring extended cycle times
• Dust or debris visible behind the door

Note: Right side

Compatible with some Kenmore dryers.