General Electric Dryer Wire, Harness, Power Cord

This cord set is a direct-replacement power cord that restores electrical connection to the appliance, letting it receive safe, consistent power when the original cord is damaged or worn. What it does:

• Provides the appliance's main AC connection so it can power on and operate
• Replaces frayed, cut, or melted cords that cause intermittent power or arcing
• Prevents unsafe wiring conditions from exposed conductors or loose connections
• Restores a secure plug/cable interface when the cord or plug is damaged

• One replacement cord set

• Always disconnect power at the breaker or unplug the appliance before replacing the cord
• Verify the replacement cord matches the original in wire count, connector type, and amp rating
• Tighten terminal screws securely and route the cord to avoid pinching or contact with hot components

This 120V replacement power cord restores household current to gas ranges and ovens that use a corded connection for clocks, lights, igniters and controls. It provides a straightforward way to replace a damaged or worn cord and regain safe power to the appliance. What it does

• Supplies 120-volt power from the wall outlet to the range/oven's control system, clock and lights.
• Restores ignition and control functions when a frayed or broken cord prevents the appliance from receiving power.
• Replaces cords that show signs of burning, cracking, loose connections, or exposed wiring.
• Reduces risk of electrical faults caused by damaged insulation or terminals.

• One 120V power cord

• Disconnect power at the circuit breaker or unplug the appliance before starting; ensure the appliance is de-energized.
• Route and secure the cord to avoid pinching; tighten terminal screws to manufacturer torque recommendations.

This door release cable connects the dryer door latch to the release mechanism so the door opens and closes reliably. Replaces a worn or broken cable to restore normal door operation and improve safety. What it does:

• Transfers motion from the door handle to the latch so the door can be opened and closed
• Helps ensure the door stays securely closed during operation
• Commonly replaced when the door won't latch or handle feels loose
• Prevents intermittent door-release failures that can stop dryer cycles

• Disconnect power before beginning any repair to avoid shock or injury
• Inspect the latch, handle, and routing path and replace any damaged clips or fasteners
• Basic hand tools typically required; follow OEM instructions for routing and attachment

This flame sensor wire is the replacement lead that connects the oven/range flame sensor to the control system, restoring reliable flame detection for safe burner operation and proper ignition control. What it does:

• Carries the sensor signal from the flame sensor to the control board so the system can detect a sustained flame
• Helps prevent repeated ignition attempts or control lockouts caused by an open or damaged lead
• Common symptom: oven or range fails to detect flame or cycles continuously during ignition
• Used where a separate sensor lead is required to maintain correct sensing and safety operation

• Disconnect power and shut off gas before servicing; follow all local codes and safety procedures
• Handle the sensor lead and connectors gently to avoid damage; ensure secure, corrosion-free connections
• Route the lead away from direct burner contact and high-heat paths to prevent premature failure