General Electric Dryer Touch Pad

This is a replacement dryer control panel that has been manufactured by General Electric. This control panel allows the user to select the desired dryer settings and cycles. It houses the buttons for these selections, as well as the display. Over time, the panel may deteriorate or become worn to the point where the user cannot read the display or select the settings. This might include the buttons becoming jammed, the display failing to light up, or general wear and tear. In such cases, immediately replace this part. Wear work gloves and unplug the dryer from the power outlet before proceeding with repair work. As an authentic OEM part, this control panel is intended for use with different brands of dryers manufactured by General Electric, Hotpoint, RCA, and other compatible brands. This part is sold individually and is a genuine part made of high-quality, durable, non-corrosive materials.

This control panel assembly replaces a damaged or worn right-side console section to restore button access and the front-facing control surface. It provides the visible panel and button openings so controls operate and look correct. What it does:

• Replaces a cracked, faded, or broken right-side control panel section
• Restores proper button alignment and access for the right-side controls
• Helps stop debris or moisture from entering the front console area
• Addresses symptoms such as unresponsive or physically damaged right-side buttons, broken panel surface, or cosmetic wear

• Disconnect power to the appliance before starting any repair to avoid shock.
• Removal typically requires accessing the console area and removing fasteners; keep track of screws and small parts.
• Handle the panel carefully to avoid scratching the finish or damaging button openings; use soft tools to pry clips.

This replacement backsplash assembly restores the rear panel behind the cooktop for a clean, finished appearance and protects the wall and internal components from spills and heat. Designed to match original fit and finish on compatible ranges. What it does:

• Replaces a cracked, dented, warped, or heavily scratched backsplash to improve appearance and safety
• Shields internal wiring and cabinet wall from splashes, grease, and heat exposure
• Provides the mounting surface and openings for controls and trim where applicable
• Helps maintain proper alignment of the cooktop-to-backguard gap and seals edges against debris

What's included: One white backsplash assembly Install notes:

• Disconnect power to the range before beginning work; follow all lockout/tagout safety practices
• Remove the cooktop or control panel per factory instructions to access mounting screws
• Handle edges carefully — sheet metal can be sharp; wear cut-resistant gloves and eye protection
• Keep all original fasteners and trim; verify alignment and fit before tightening permanently