General Electric Range / Cooktop / Oven Bracket & Flange

This control bracket secures and positions the range/oven control assembly so the console stays stable and the control board is properly aligned. Replacing a damaged bracket restores firm mounting and reliable button/knob operation. What it does:

• Mounts and supports the control board/console to the appliance cabinet
• Keeps the control panel aligned to prevent rubbing, vibration, or mispositioned buttons
• Prevents the control assembly from shifting during use, which can cause intermittent controls
• Helps maintain consistent button/knob actuation and overall console stability

• Disconnect power to the appliance before starting any repair
• Access usually requires removing the console or control panel; keep or note screw/hardware locations
• Handle the control board and wiring gently to avoid connector or component damage

This mounting bracket secures the appliance switch in place to maintain reliable switch alignment and operation. It's a simple replacement that restores proper switch positioning and helps prevent intermittent or failed switch contact. What it does

• Holds the switch assembly firmly in the correct position for consistent operation
• Prevents switch movement that can cause intermittent operation or failure to engage
• Commonly replaced when a loose or broken bracket causes the appliance not to start, stops mid-cycle, or has inconsistent controls
• Compatible with the factory switch design to maintain original fit and function

• Disconnect power to the appliance before starting any repair
• Basic hand tools are typically required; keep screws and small parts organized
• Handle the switch and wiring carefully; avoid pulling on wires during replacement
• After installation, restore power and test the switch operation before reassembling panels

Mounting bracket that secures the radiant heating element to your range cooktop. Replace if bent, broken, or corroded to properly support the element.

Right hand side

This bracket secures the oven/range hot surface indicator light so the indicator stays properly positioned and visible. It restores the light's mounting after breakage or wear, helping you know when a surface or element is hot. What it does:

• Holds the hot surface/indicator light in the correct position behind the console or cooktop lens
• Keeps the indicator light aligned and stable so the hot-surface warning is visible
• Replaces a cracked, bent, or missing bracket that causes a loose or non-seated indicator
• Helps prevent the indicator from rubbing against other components

• One replacement hot light bracket

• Disconnect power to the appliance before starting any repair
• Remove control panel or bezel per your model's service instructions to access the bracket
• Support and align the indicator lamp while fastening the bracket to avoid damaging the bulb or lens

This is a replacement bracket that secures the cooktop/range hot surface indicator lamp so you can see when a surface is hot. It restores proper positioning and support for the indicator light assembly. What it does

• Holds the hot surface indicator lamp in the correct position for visible, reliable indication
• Keeps the lamp aligned and stable to prevent rubbing or disconnection during use
• Helps maintain the cooktop's visual hot-surface warning so users avoid accidental contact
• Compatible with the original indicator lamp assembly design and mounting points

• One hot light bracket (mounting bracket) as shown

• Disconnect power to the appliance before starting any work to avoid shock or injury
• Handle indicator lamp and wiring gently; avoid pulling on wires or touching bulb glass with bare hands
• Retain original screws and clips unless replacement fasteners are specified