General Electric Range / Cooktop / Oven Control Board

This main display board replaces the console control module that shows time, oven temperature, and cycle status so the oven's display and touch controls work properly. Restores visible readouts and control responsiveness. What it does:

• Powers and drives the front display and electronic touch/sensor controls
• Updates clock, cook settings and cycle status shown on the console
• Helps resolve issues like blank or flickering display, incorrect readouts, or unresponsive touch controls
• Works with the console wiring and user interface to relay commands to the oven control system

• One main display (console control) board

• Disconnect power at the breaker before starting any repair
• Handle the board carefully to avoid static damage; use anti-static precautions if available
• Remove the console/faceplate per service instructions to access the board; keep screws and connectors organized
• Verify wiring connectors match and seat fully before restoring power; test functionality after reassembly

This OEM electronic oven control (ERC3HP) manages your range's timing and cooking functions to restore normal oven operation and user-interface control. It replaces the main control assembly for models that use the ERC3HP module. What it does:

• Controls oven bake, broil, and timer functions so the oven responds to user commands
• Manages clock and display logic to show time and settings
• Restores normal electronic control when the original ERC is unresponsive or shows interface errors
• Stops symptoms like unresponsive touchpad, incorrect cycle behavior, or blank/erratic display

• One oven electronic control (ERC3HP) board

• Disconnect power to the appliance at the breaker before starting any repair
• Handle the control board carefully and avoid touching circuit traces or components
• Some disassembly (back panel or console) is required; keep track of screws and connectors

This electronic oven control replaces the oven's main control board to restore timed bake/clean cycles and oven temperature control. It helps recover lost display, non-responsive keypad, or heating problems caused by a failed control. What it does:

• Replaces the oven's electronic control module that manages bake, broil, timer, and self-clean functions
• Restores the control display and keypad responsiveness when the control is unresponsive or shows errors
• Helps correct ovens that fail to start or maintain temperature due to control failure
• Addresses intermittent or erratic oven operation linked to a faulty control board

• Turn off power to the appliance at the breaker before accessing or replacing the control
• Handle the control by its edges and avoid touching circuit components; wear anti-static protection if available
• Verify wiring placement matches original; take a photo before disconnecting connectors to ensure correct reassembly

This filter board is the electronic control board that monitors and communicates your refrigerator's filter status and related dispenser signals, restoring proper filter detection and indicator operation. What it does

• Monitors filter presence and communicates filter status to the display or dispenser
• Sends/receives signals that enable filter-related indicator lights and alerts
• Helps restore dispenser/filter indicator functionality when the original board fails
• Common symptom: filter status light stays on or does not change after replacing the filter
• Common symptom: dispenser or filter indicator behaves intermittently or not at all

• Disconnect power to the appliance before starting service to avoid shock
• Handle the board by the edges and avoid touching contacts; protect against static discharge
• Access typically requires removing the dispenser/display or control housing—retain screws and mounting hardware

The Touch Control Board is an OEM part for GE electric cooktop. It serves as the main interface between electronic controls and user inputs. This board mounts behind touchpad buttons and digital displays to enable adjustments, programming and monitoring of oven functions. 

Symptoms of a bad touch control board include:

• Dual-function keys sticking or not responding properly
• Display backlights failing or fading out intermittently
• Error codes or cooking presets not engaged accurately
• Controls freezing, glitching or showing incorrect temps

Causes can stem from water damage, electrical faults or high contact wear over years of regular daily use.

This OEM GE replacement is compatible with Hotpoint, RCA and select Kenmore wall oven models as well.