General Electric Range / Cooktop / Oven Endcap Parts

This right-side end cap replaces a worn or broken trim cap to restore a finished look and protect the exposed edge. It fits at the end of the trim piece to help prevent snagging and covers hardware for a clean appearance. What it does:

• Covers and protects the outer end of the trim/rail on the right side
• Helps prevent cuts, snags, and dirt buildup on exposed edges
• Restores a finished appearance when the original cap is cracked, chipped, or missing
• Works with the matching left-side cap to maintain trim alignment and fit

• High-level: usually snaps or slides into place; may require removal of adjacent trim for access
• Use gentle pressure and avoid forcing to prevent damage to trim or cap
• Disconnect power or follow appliance safety guidelines if working near electrical components

This cap end light protects and secures the oven/refrigerator lamp connection so the interior light stays covered and aligned. It's a small replacement part that restores a proper lamp seal and electrical contact. What it does

• Covers the exposed end of the interior lamp to protect the bulb and wiring
• Holds the lamp in correct position for reliable illumination
• Prevents light assembly rattles or misalignment
• Can resolve interior light flicker or failure when the cap is cracked or damaged

• One cap end light

• Disconnect power before servicing any appliance light or electrical component
• Remove the old cap by hand or with basic tools; press the new cap into place until secure
• Inspect the bulb and socket for corrosion or damage when replacing the cap

Replacement endcap for your range. This plastic or metal trim piece covers the end of the control panel or cooktop edge. Order a new one if yours is cracked or missing.

White plastic endcap for range. Installs on the side trim to cover exposed edges. Replace if cracked, broken, or missing for a finished look.

Replace your range's control panel end cap if the original is cracked, broken, or missing. This trim piece installs on the right side of the panel.

Left end cap cover for ranges. Replaces worn, cracked, or missing outer trim piece. Restores finished appearance and protects internal components.