General Electric Range / Cooktop / Oven Latch, Catch, Lock Parts

This is a range oven door lock motor. It is a small part that can be found near the upper portion of an oven door. The main function of a range oven door lock motor is to lock the oven when the unit is put into self-cleaning mode, preventing it from opening until the cycle is complete. This part will need to be replaced if it no longer locks properly, or is locking erratically during self-cleaning mode or even locking when it should not be locking at all. Running self-cleaning mode too often or for too long can overheat the door lock, causing it to break.When replacing this part, first ensure that the range is off by unplugging it from its power source. A nut driver set and a screwdriver will be helpful to ensure a swift repair. Protective gloves should be worn for safety during the replacement process. This motorized door lock is designed for a General Electric range oven. This product is also sold as a single unit. It is an authentic OEM replacement part, and it is also sourced directly from the manufacturer.

This oven door latch assembly secures the oven door and enables proper latching during oven operation, restoring safe door closure and allowing functions that require a locked door such as self-clean cycles. What it does:

• Replaces a worn or broken door latch so the oven door closes and stays latched
• Allows the oven to detect a closed/latched door for safe operation and self-clean cycles
• Helps stop heat loss from the oven cavity due to a door that won't fully close
• Common symptoms include a door that won't latch, a door that won't stay closed, or an oven that will not start self-clean

• One oven door latch assembly

• Disconnect power to the appliance before starting any repair
• Access may require removing the oven door or inner door panel—follow the oven's service manual
• Handle parts and glass panels carefully; wear gloves and eye protection

A replacement door catch that secures the appliance door/panel in the closed position to restore proper sealing and normal operation. Installs quickly to stop doors from popping open or not staying latched. What it does:

• Holds the appliance door or access panel closed during use
• Helps maintain interior temperature and prevents gaps that can cause performance issues
• Commonly used when a door won't stay shut, pops open, or fails to latch
• Works with the door striker or mating latch to provide a positive stop

• One door catch

• Disconnect power (and water if applicable) before starting any repair
• Remove the door or access panel per your model's service instructions to reach the catch
• Typically secured with screws or clips; retain all fasteners and note orientation for reassembly