General Electric Range / Cooktop / Oven Screws, Nuts, Washers

A replacement 8-32 x 7/8 inch truss-head screw that secures appliance panels and components. Replaces a lost or damaged fastener to restore proper fit and prevent loose or rattling parts. What it does:

• Secures control panels, brackets, trim pieces or internal components in place
• Restores proper alignment and prevents vibration or rattling caused by missing or stripped screws
• Provides the correct thread and length for reliable fastening where specified
• Used when original screw is missing, corroded, or damaged

• One 8-32 x 7/8 in. truss-head screw

• Disconnect power to the appliance before beginning any repair
• Use the correct screwdriver or driver bit to avoid stripping the head
• Install by hand first, then tighten securely—do not overtighten to avoid damaging threads or components
• Replace with the exact OEM part number if the original fit or material finish is required

Replacement washer for ovens and ranges. Secures components and provides spacing between fasteners and surfaces. Order when original is missing or worn.

This is a flat-head screw used to secure panels and components in compatible appliances. It provides a flush finish and reliable fastening for trim, interior panels, and small assemblies. What it does:

• Fastens trim, brackets, and small appliance components with a flat, countersunk head
• Provides a flush surface to prevent snagging and keep panels aligned
• Commonly used where a low-profile finish is needed for aesthetics and clearance

• One screw

• Use the matching Phillips or screwdriver bit; avoid over-tightening to prevent stripping
• Inspect mating threads and replace if damaged; use correct screw length to avoid puncturing internal components
• Disconnect power or follow appliance safety procedures before servicing