General Electric Range / Cooktop / Oven Screws, Nuts, Washers

This is a replacement 8-32 machine screw used to fasten panels, brackets and components on household appliances. It restores secure attachment and helps stop rattling or loose parts caused by missing or damaged fasteners. What it does

• Secures trim, control panels, brackets and electrical component mounts
• Stops rattling or vibration caused by loose or missing screws
• Replaces stripped, missing or corroded screws to restore proper fit
• Works wherever an 8-32 threaded machine screw is required

• Turn off and unplug the appliance before servicing to avoid electrical shock
• Use the correct driver and size to avoid stripping the head or threads
• Hand-start the screw and tighten progressively; avoid overtightening to prevent damage
• If threads are damaged, replace the mating nut or threaded insert as well

This 10-32 threaded machine screw secures panels, controls, and brackets on compatible appliances to restore stable mounting and stop loose or rattling parts. Use it wherever the original 10-32 fastener has worn, stripped, or gone missing. What it does:

• Fastens control panels, trim pieces, mounting brackets, and grounding or terminal connections using a 10-32 thread.
• Replaces worn or damaged screws that cause loose panels, vibrating noise, or poor alignment.
• Restores secure electrical and mechanical connections when the original fastener is stripped or corroded.
• Works with standard 10-32 tapped holes and mating nuts designed for this thread size.

• One 10-32 machine screw

• Disconnect power and follow appliance safety procedures before starting any repair.
• Use the correct screwdriver or nut driver sized for the screw head to avoid cam-out or damage.
• Tighten until snug—do not overtighten to prevent stripping the threads or damaging components.
• If threads in the mating part are damaged, replace or re-tap the mating component rather than relying on over-tightening.

This screw mounting end cap secures the end of a screw mounting channel or trim, keeping panels and components held firmly in place for stable operation and reduced vibration. What it does:

• Covers and retains the end of a screw or mounting channel to prevent screws from backing out
• Keeps adjacent panels, trim, or assemblies aligned for proper fit and finish
• Helps eliminate rattling or looseness that can occur when end caps are missing or damaged
• Small replacement part for restoring secure fastener retention

• Disconnect power to the appliance before starting any repair.
• Remove the affected panel or trim to access the mounting channel; use appropriate hand tools.
• Align the cap over the screw/mounting channel and press or fasten per the original attachment; do not force a damaged part into place.
• Replace any stripped or damaged screws or retainers to ensure a secure fit.