General Electric Range / Cooktop / Oven Trim

A 27" stainless trim assembly that restores the finished edge and appearance of the appliance front. Replaces damaged or missing trim to improve fit and restore a clean, professional look. What it does:

• Covers and protects the appliance front edge while providing a finished stainless appearance
• Helps align and secure adjacent panels or control bezels for a consistent fit
• Commonly replaced when trim is dented, scratched, bent, or missing
• Restores visual uniformity after panel repairs or replacements

• Disconnect power to the appliance before beginning any work.
• Basic hand tools (screwdriver, nut driver) are typically required; mounting hardware may be retained from the original part.
• Handle trim carefully to avoid scratches; use a soft cloth when aligning into position.

This 30" stainless trim assembly replaces the front trim on compatible 30-inch ranges and ovens to restore a clean, finished appearance and protect the front edge from chips and wear. What it does:

• Replaces damaged, dented, or scratched front trim to improve appliance appearance
• Restores the finished edge where the door or cooktop meets the control area
• Helps maintain a consistent fit and finish with other stainless trim pieces
• Can reduce drafts or gaps caused by warped or bent trim (visual and fit improvement)

• One 30" stainless trim assembly

• Disconnect power to the appliance before beginning any repair
• Handle trim edges carefully; use gloves to avoid cuts and protect the finish
• Typical installation uses the factory screws or clips; keep fasteners from the original trim if they're undamaged

This landing edge kit replaces the worn or damaged landing edge on compatible GE appliances to restore a secure, even door or panel fit and reduce drafts or rubbing. Designed as a direct-fit service part for affected models. What it does

• Replaces the landing edge strip that provides a finished, cushioned contact surface for a door or panel.
• Helps stop scraping, rattling, or uneven closing caused by a worn or torn landing edge.
• Restores the proper seal/contact area to reduce air leaks and improve door alignment.
• Keeps surrounding trim from wearing prematurely by providing a consistent contact surface.

• One landing edge kit (ZDP) as shown.

• Verify accessibility and remove power from the appliance before starting.
• Clean the mounting area and remove old adhesive or remnants to ensure good fit and adhesion.
• Use appropriate hand tools; avoid sharp tools that could damage adjacent trim or seal surfaces.
• Follow any model-specific instructions in the service manual for proper positioning and attachment.

This eyebrow decorative trim restores the top-front appearance of the appliance and covers the control-area seam for a clean, finished look. It replaces damaged, dented, or worn trim to improve how the unit looks. What it does:

• Covers and protects the upper front edge/control-area seam from dirt and damage
• Restores original appearance after dents, chips, or cosmetic wear
• Hides mounting hardware and provides a finished trim line
• Helps maintain resale value by repairing visible exterior damage

• High-level replacement; typically removed and installed with basic hand tools
• Handle carefully to avoid scratching the finish during installation
• Disconnect power to the appliance before removing trim panels near electrical components
• If fasteners are corroded or damaged, replace with OEM-equivalent parts

Color: Bisque