General Electric Range Parts

Black control knob for gas range top burners. Mounts on valve stem to adjust heat settings. Replace worn, cracked, or missing knobs to restore control.

Replaces the handle on your range's lower broiler drawer. Install this part if your current handle is cracked, broken, loose, or missing.

If your oven won't heat or displays error codes, the relay board may have failed. This assembly routes power to burners and heating elements.

Fix a convection fan that won't turn or hums but doesn't spin. This motor restores proper convection cooking. Moderate DIY repair with basic tools.

This tangential blower moves cooling air through the appliance to protect internal components and the control area from excess heat. Replace a noisy or non-running fan to restore proper airflow and safe operating temperatures. What it does

• Circulates air across the appliance cavity and control compartment during and after heating cycles
• Helps prevent over-temperature shutdowns and protects electronic controls
• Reduces heat at the control panel and vent area
• Common symptoms: fan won't run, runs intermittently, or makes loud scraping/rumbling noises

• One tangential blower

• Disconnect power and allow the appliance to cool completely before servicing
• Access location varies by model; document wire connections and mounting orientation before removal
• Transfer any brackets, screws, or insulation from the original part if needed
• The fan spins freely and matches the original airflow direction before reassembly

Decorative overlay for range control console. Restores button labels and appearance. Replace when cracked, worn, faded, or peeling. Protects electronics.

Fix an oven that shuts off during cooking or won't maintain temperature. This range control board monitors heat and sends power to the oven elements.

Outer trim for your range control area. Replaces scratched, cracked, or worn faceplates. Covers and protects control buttons and display panel.

This 250V 15A safety fuse protects the appliance's line circuit from overcurrent. When the original fuse has blown, replacing it can restore power and help safeguard internal components from further damage.

• Opens the circuit if excessive current or a short occurs, protecting internal parts
• Common symptom: unit completely dead—no display, lights, or response to controls
• Blown fuse will test open (no continuity) with a multimeter
• If a new fuse blows again, another component may be shorted and needs diagnosis

• Unplug the appliance before servicing; microwaves can retain a dangerous charge—discharge the high-voltage capacitor
• Access the fuse near the line filter/control area; note clip orientation
• Replace only with the same 250V 15A rating; never bypass or upsize the fuse
• If the replacement fuse blows immediately, stop and troubleshoot the root cause

Pre-formed gas line that connects the inlet regulator to the burner manifold in gas ranges. Replace if damaged, cracked, or leaking to restore safe operation.

Cast iron grate supports pots and pans above the burner flame. Replace yours if cracked, warped, or broken to restore a stable cooking surface.

Cushions and protects your range door or cooktop when opened or closed. Replace this bumper if it's cracked, broken, worn, or missing to reduce noise.

Oven door won't stay closed or latch properly? This oven door latch mechanism secures your range door during cooking. Moderate DIY repair in 30-45 minutes.

Black thermostat control knob for range ovens. Replaces worn, broken, or missing temperature knobs. Restores smooth turning and clear pointer alignment.

Replace a cracked, stripped, or missing oven thermostat knob. Attaches to the thermostat shaft to restore secure temperature selection.

Fix loose or wobbly burner connections with this terminal block mounting bracket. Secures the element receptacle so coils plug in firmly and heat properly.