General Electric Range Parts

Replace a cracked, stripped, or missing oven thermostat knob. Attaches to the thermostat shaft to restore secure temperature selection.

Burner base mounts beneath the burner cap on gas range cooktops. Replace if cracked, corroded, or damaged to restore proper burner alignment and appearance.

Controls status lights on your cooktop, providing visual alerts during operation. Replace when indicators fail or become dim. Snaps into place for easy installation. Verify fit with your model number.

Secures components to your appliance chassis for a rattle-free fit. Replace missing, stripped, or corroded screws to keep panels and brackets aligned.

Oven shuts off at high temps or won't maintain set temperature? This capillary thermostat monitors cavity heat to regulate baking performance accurately.

Black touch pad overlay for range control panel. Replaces worn, faded, or cracked overlays. Installs over existing control board for a refreshed appearance.

Fixes cooktop display issues and control failures caused by power supply problems. This transformer converts household voltage for stable operation.

If your range display is blank or buttons don't respond, this oven control board manages temperature cycles and the clock. Straightforward repair in 15 minutes.

This 250V 15A safety fuse protects the appliance's line circuit from overcurrent. When the original fuse has blown, replacing it can restore power and help safeguard internal components from further damage.

• Opens the circuit if excessive current or a short occurs, protecting internal parts
• Common symptom: unit completely dead—no display, lights, or response to controls
• Blown fuse will test open (no continuity) with a multimeter
• If a new fuse blows again, another component may be shorted and needs diagnosis

• Unplug the appliance before servicing; microwaves can retain a dangerous charge—discharge the high-voltage capacitor
• Access the fuse near the line filter/control area; note clip orientation
• Replace only with the same 250V 15A rating; never bypass or upsize the fuse
• If the replacement fuse blows immediately, stop and troubleshoot the root cause

Burner not heating or center ring fails? Replace the tri-ring radiant element. Most DIYers complete this repair in 15-30 minutes with a screwdriver.

Seals the oven door to retain heat and maintain even temperatures. Replace when torn, worn, or heat escapes. Confirm fit with your model number.

Insulation pad that lines the inside of your range oven door. Replace if torn, burnt, saturated, or missing to restore thermal barrier performance.

Positions your range handle at the correct distance from the door. Replace if worn, missing, or cracked to restore proper alignment and prevent rattling.

Seals the convection fan assembly to prevent air leaks and maintain even heat distribution. Replace if you notice uneven cooking or temperature fluctuations.

Cushions and protects your range door or cooktop when opened or closed. Replace this bumper if it's cracked, broken, worn, or missing to reduce noise.

This small cooktop bracket secures designated components beneath the cooktop surface, keeping them properly positioned and stable. Replace a damaged or missing bracket to restore alignment and reduce movement or rattling during use.

• Provides mounting support for specific under-top components, per model design
• Helps maintain proper alignment and stability of cooktop parts
• Replace when visibly bent, cracked, or corroded

• Disconnect power; for gas models, also shut off gas and allow the unit to cool
• Remove surface components as required (grates/caps/heads for gas; elements/panels for electric) to access under the top
• Lift or remove the cooktop as directed in your model's service information and secure the new bracket with existing hardware
• Reassemble, verify alignment, and for gas units check for leaks if any gas connections were disturbed