General Electric Wall Oven Trim

This filler panel assembly fills the gap between the dishwasher and adjacent cabinetry for a clean, finished look. Designed to match stainless or white finishes, it restores proper coverage and improves appliance appearance. What it does:

• Covers the gap between the dishwasher and cabinets to prevent debris and improve the look of the installation
• Restores the factory trim/edge where a damaged or missing panel exposes the dishwasher side
• Helps maintain a consistent finish between the appliance and surrounding cabinetry
• Compatible with factory mounting locations and trims when used as a direct-replacement part

• Designed for direct replacement using existing mounting points; keep original fasteners unless damaged
• Turn off power to the appliance before beginning work and follow all safety instructions in your appliance manual
• Use proper tools and a helper if needed; panels can be awkward to hold during alignment

This bottom trim assembly replaces the lower front trim on compatible 30" ranges and wall ovens, restoring a clean finished look and helping direct airflow. It's a direct-fit exterior replacement that refreshes damaged or discolored trim. What it does:

• Replaces the lower front/bottom trim piece to restore appearance and proper panel alignment
• Helps close the gap between the oven/range cabinet and the floor for a finished look
• Addresses symptoms like cracked, dented, warped, or yellowed lower trim
• Maintains proper airflow profile at the appliance base (cosmetic/exterior component)

• One bottom trim assembly (30" white) as pictured

• High-level swap: remove kick plate/old trim and fasten replacement with existing screws/clips
• Use basic hand tools; avoid force that could strip screws or damage adjacent panels
• Disconnect power at the breaker if service requires moving or tilting the appliance
• If mounting hardware is missing or damaged, verify exact fastener type before installation

This is a bottom cabinet trim assembly that restores the lower front appearance of the appliance and helps cover the gap between the cabinet and floor for a finished look. It replaces worn or damaged lower trim to improve fit and appearance. What it does:

• Covers and finishes the appliance's lower front edge for a clean, uniform appearance
• Replaces cracked, bent, or missing trim that exposes internal components
• Helps keep dust and debris from entering the cabinet area beneath the appliance
• Matches the original black finish to maintain the appliance's factory look

• Disconnect power to the appliance before starting any work
• Typically installs with screws or snap clips; retain original fasteners if reusing
• Handle trim carefully to avoid scratching the finish during installation

This white middle trim assembly replaces damaged or worn center trim on compatible GE refrigerators, restoring a clean finished look and helping maintain proper door alignment and a consistent fit between doors. What it does:

• Replaces cracked, broken or missing center trim for a neater exterior appearance
• Helps maintain proper spacing and alignment between doors or panels
• Keeps dirt and debris out of the trim channel for smoother door operation
• Restores the intended fit where trim has become loose or warped

• Disconnect power to the appliance before starting any repair.
• Remove surrounding trim or screws as required; trim typically snaps or screws into place.
• Handle gently to avoid damaging adjacent panels or clips; replace any broken clips or fasteners.
• After installation, verify doors align and seal properly; make adjustments if needed.