General Electric Washer Dryer Combo Parts

Exhaust duct channels air from your laundry center to the venting system. Replace if cracked, disconnected, or damaged to restore proper airflow.

This motor, switch & pulley assembly drives the drum and controls motor operation so your dryer tumbles and heats correctly. Direct-fit replacement for the original equipment assembly to restore normal drum rotation and motor switching. What it does:

• Powers drum rotation by coupling the motor to the drive system
• Houses the motor switch that controls on/off and safety switching
• Includes the pulley that routes the drive belt and maintains belt tension
• Commonly replaces worn pulley, failed switch, or motor-related tumbling issues
• Stops dryer from tumbling, causes loud squeaks, or prevents motor start when failed

• Disconnect power before starting any repair to avoid shock or injury
• This assembly typically mounts in the dryer cabinet and may require belt removal and basic hand tools
• Inspect the drive belt and mounting hardware while installing; replace if damaged

Dryer won't start or drum won't turn? This motor assembly drives drum rotation. Moderate difficulty repair, typically takes 45-60 minutes to replace.

Protective cover for the main wiring harness on laundry centers and washer-dryer combos. Replaces cracked, broken, or missing covers that expose wiring.

Left side panel for washer dryer combo units. Replaces cracked, dented, or discolored exterior panels. Restores cabinet appearance and protects internal components.

Right side panel for washer dryer combo units. Replaces cracked, dented, or damaged exterior panels. Restores cabinet appearance and structure.

Replacement control panel trim that covers the control area of your laundry center. Needed when the original panel is cracked, warped, or worn.

Replacement top panel for laundry center units. Covers the upper exterior surface. Needed when original panel is cracked, dented, or discolored.

Control panel wire harness for laundry centers. Connects the control board to the front panel. Replace if wires are damaged, frayed, or loose.

8-18 x 5/8-inch Torq II screw secures panels, brackets, and trim on laundry centers. Replace stripped, missing, or damaged screws to restore fit.

Secure your dryer motor with this mounting clamp. Replace if motor vibrates excessively or becomes loose. Verify fit with your model number.

Roller shaft for dryer drum support system. Replaces broken, worn, or damaged shafts that cause drum rollers to fail. Essential structural component.

Door switch lever for dryers. Activates the door switch mechanism when the door closes. Replace if cracked, broken, or missing to restore proper door operation.

Replacement leveling foot for washer dryer combos. Adjusts appliance height to eliminate rocking on uneven floors. Order a new foot if original is cracked or missing.

This ring drain hose is the replacement drain tube that routes and removes water from the appliance, restoring proper drainage and preventing leaks or standing water in the wash area. Designed to match the original fit and function. What it does:

• Channels wastewater from the tub/pump to the household drain to maintain normal drain cycles
• Restores proper drainage when the original hose is cracked, kinked, or leaking
• Helps prevent leaks and water damage caused by failed or deteriorated hoses
• Compatible with compatible stock mounting points for a like-for-like replacement

• One ring drain hose (1 piece) as pictured

• Disconnect power and water supply before servicing to avoid shock or flooding
• Inspect adjoining clamps and fittings; replace clamps if corroded or damaged for a secure seal
• Ensure hose routing is free of sharp bends or kinks and is secured per the appliance's service instructions