General Electric Washer Leg Or Foot

This left-side level leg assembly provides an adjustable support to stabilize and level your appliance for safe, wobble-free operation. Durable construction restores proper height and helps prevent tipping or uneven loads. What it does:

• Replaces a worn or damaged left leveling leg assembly to restore stable support.
• Allows height adjustment to level the appliance on uneven floors.
• Helps reduce vibration, rocking, and noise caused by uneven footing.
• Supports safe operation and proper door alignment where applicable.

• One left-side level leg assembly

• Requires basic hand tools; your appliance manual for access steps.
• Adjust height with the appliance in the intended location; ensure power is off and the appliance is secure before working.
• If lifting the appliance is needed, use safe lifting techniques or get help to avoid injury.
• Left/right orientation matches your appliance before installation.

This right-side leveling leg assembly replaces a worn or damaged support leg to stabilize and level the appliance for proper door alignment and operation. It restores a steady foundation so doors close evenly and the unit sits flush on the floor. What it does:

• Provides adjustable support to raise or lower the right front corner of the appliance
• Helps stop rocking, wobbling, or uneven sit when floor surfaces are irregular
• Restores correct door alignment and sealing when tilt causes gaps
• Transfers cabinet weight to the floor for stable operation

• One right-side leveling leg assembly

• Disconnect power (and water if applicable) and remove food/items from doors before working near the appliance
• Support the appliance with a jack or help to safely relieve weight while replacing the leg
• Thread the leg in or out with hand or wrench to adjust height; make small adjustments and re-check level
• Do not overtighten; ensure secure fit and stable contact with the floor