General Electric Washer Panel Parts

This top cover assembly replaces the appliance's damaged or worn top panel to restore a clean, finished appearance and protect the internal controls and wiring from debris. Fits the factory mounting points for a direct replacement. What it does:

• Covers and protects the control area, wiring and internal components from dust and spills
• Restores the appliance's exterior appearance when the original top is dented, cracked or rusted
• Provides the correct mounting surface for the control console and trim pieces
• Helps keep components properly shielded during normal use

• Disconnect power to the appliance before starting any work
• Remove the control console and screws securing the old top; handle edges carefully—they can be sharp
• Align the replacement top to factory mounting points and reattach hardware and any trim

This lid assembly kit replaces a damaged or broken top-load washer lid to restore a secure, flush cover and proper lid operation. Designed as a direct replacement to help the washer close and latch correctly. What it does:

• Replaces a cracked, warped or broken washer lid that no longer closes or stays shut
• Restores a proper fit and alignment so the lid can latch and allow normal cycle operation
• Prevents debris from entering the wash tub through a damaged opening
• Helps reduce noise and vibration caused by a loose or ill-fitting lid

• Disconnect power to the washer before starting any work
• Follow the manufacturer's service instructions and use appropriate tools for removal and installation
• Check lid alignment and latch engagement during installation to ensure proper operation
• If you find additional damaged parts (hinge, latch, strike), replace those components per OEM recommendations

This cabinet rear cover replaces the damaged or missing rear panel on the appliance cabinet to protect internal components and help maintain proper airflow. It restores a finished rear appearance and helps keep wiring and parts enclosed. What it does:

• Covers the back of the cabinet to protect wiring, components and insulation from debris and contact
• Helps maintain intended airflow and prevents drafts through the rear of the appliance
• Stops snagging or accidental contact with internal parts that could cause damage or noise
• Prevents pests and dust from entering the cabinet area

• Always disconnect power (unplug or shut off breaker) before servicing the appliance
• Removal/installation typically requires removing a few screws; keep fasteners for reuse
• Handle edges carefully — panel edges can be sharp
• Verify proper fit and alignment before securing; ensure no wires are pinched

This front panel is the painted white exterior trim that restores the oven/range front for a clean, finished appearance and protects internal components from spills and heat. It helps maintain appliance cosmetics and proper airflow around controls. What it does

• Replaces damaged, dented, or discolored front trim to restore appearance
• Covers and protects switches, knobs, and internal components from splashes
• Helps maintain proper front airflow and fit of control/door assemblies
• Reduces gaps and rattles caused by bent or warped panels

• One painted white front panel

• Disconnect power before starting any repair to prevent shock or injury
• Minor disassembly of the cooktop/control bezel or door may be required for access
• Use care to align mounting tabs and fasteners to avoid stripping or bending
• Replace damaged screws or clips with OEM-style fasteners for secure fit