Need Help?
Call or text
Top front mounting bracket for washers. Secures and stabilizes the front panel assembly. Replace if cracked, broken, or missing for proper alignment.
Usually ships within 4 - 14 days
This ATC wiring harness connects the appliance's ATC control to the wiring harness, restoring reliable electrical connections for temperature/controls. It's a direct-fit replacement that helps resolve intermittent power or control failures caused by damaged wiring. What it does
Suspension spring for washer tub support system. Replaces worn, broken, or missing springs that cause imbalance. Installs between tub and frame.
Fix a washer that won't spin or agitate properly with this brake and clutch assembly. Common solution for loud grinding noises during spin cycle.
Washer won't spin or agitate? A faulty motor assembly often causes complete failure to run. This replacement restores full washing function.
Secures the washer lid hinge to the cabinet for proper alignment. Replace if screw is stripped, missing, or broken to restore smooth lid operation.
Siphon and vacuum break assembly for washers. Installs on the water inlet system. Replace if cracked, broken, or leaking to restore proper function.
Balance ring assembly mounts to the outer tub of your washer to stabilize the drum during spin cycles. Replace if cracked, damaged, or leaking fluid.
If your washer won't stop spinning or makes grinding noises, this brake shoe outer may be worn. Moderately difficult repair requiring basic tools.
Washer won't start or interior light not working? This door switch completes the circuit when the door closes. Moderate DIY repair with basic tools.
Replaced door lock. It required removing the two screws around the lock, pulling the spring hoop wire from around the door gasket, and then disconnecting the two wire terminals from the lock. Reverse with the new part. After cracking open the old lock the failure was caused by a thin plastic tab breaking off. I also bought the door switch since it's cheap - just in case the problem was not the lock. But the door lock was the fix. Read more
Flat washer for GE washing machines. Spaces and secures fasteners between components. Replace if worn, missing, or damaged to maintain proper alignment.
The driver pulley had loosened causing the belt to slip off. Replaced the pulley and belt. Works great again and quiet while spinning. This YouTube video has a great tip for using cable ties for getting the new belt on, which is really tight. https://youtu.be/qjN9Ibz6Azs Read more
Replace the washer tub front bulkhead if cracked, warped, or damaged. Supports the drum and mounting surfaces for proper alignment and operation.