Ikea Gasket & Seal

Removed front panel from refrigerator door and replaced the ice chute door seal and also replaced the seal inside the door that seals against the ice maker. Read more

First tried replacing the seal around the door as that was the simple and most logical fix. Still leaked. Removed the front and upper panel to inspect. Found calcium deposit running down from under the Air Vent Assembly and wet behind the black stick-on insulation. Easy to trace the leak to the bottom of the door. => Ordered new Air Vent Assembly, gasket and Vent Deflector. Parts arrived. Took 5 minutes to remove upper panel. Removed the two wires from the Air Vent Assembly. Inserted a... Read more

Ordered the correct gasket, watched video and completed the repair myself. Wasn’t hard at all. Read more

Replaced the upper spray arm tube with a new one. Also replaced delivery tube grommet and the delivery tube gasket. Now everything works fine and no more leaks. Read more

Bought a replacement gasket. Read more

Removed existing gasket and replaced with new gasket in less than 5 minutes. Very Easy. Make sure to remove the lower burner cover (inside the oven) which allows you to pull the end gasket material through the two circular openings in the frame. Read more

Replaced with a new one. Read more

Replaced a new rubber seal, it took me approx forty minutes. It works perfect, the door seals correct now. Thanks to the instruction supplied from appliance parts pros.com. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

I first thought the leak came from the pump assembly rear o ring. I was wrong. The water was leaking from the pump. The pump assembly was shipped in 1 1/2 days with 2 more o rings. I lubed the o rings with dish soap, they slid in perfectly. reinstalled the clamp and screws and was ready to reinstall the dishwasher. Worked great. Next time I will buy the pump the first time. Buying the o rings separately adds $$. Read more

Dishwasher washer would not drain after hearing glass-like particles during the drain cycle despite trying to clean the cylinder filter. Originally suspected the drain motor was damaged. After watching a video on how to replace the drain pump, I carefully energized the dishwasher (from water and electricity) then removed the dishwasher to take a look. After removal of drain hose from the pump, discovered that drain hose was connected to water inlet assembly which also needed removal to... Read more

Replace with new Read more

Removing was easy. Pull out the ends of the seal, the ends aren't locked in. Then, pull up on each retaining clip. Each clip is held in with spring tension. Reinstallation was easy too. Start on one end, Twist frayed end into cone-like shape and insert into one of the holes for the seal. Push in with a skewer/screwdriver. Insert first clip into the first hole. Go around in a linear fashion, inserting each clip into each hole. After the last clip is pushed in, twist the end of the frayed end... Read more

Located appropriately sized door gaskets. Read more