Jenn-Air Clip Or Clamp

This thermistor clip secures the refrigerator/freezer temperature sensor in the correct position for accurate temperature readings and consistent cooling. It helps keep the sensor stable so the control can properly monitor and adjust appliance temperature. What it does:

• Holds the thermistor/sensor in place on evaporator or cabinet surfaces to ensure reliable contact
• Helps prevent sensor movement that can cause incorrect temperature readings or erratic cooling cycles
• Supports proper airflow around the sensor for accurate thermostat feedback
• Simple, passive mounting solution that maintains sensor location after service

• Includes: 1 thermistor clip

• Designed for a direct replacement; remove power to the appliance before servicing
• Handle the sensor and wiring gently to avoid damage to the probe or connector
• Confirm sensor location per manufacturer guidance before clipping to ensure correct placement

This small plastic retainer clip secures trim, panels or wiring in place to prevent rattles and keep components aligned. It provides a simple, durable hold so parts stay seated and operate quietly. What it does

• Secures trim, panels or wiring harnesses to the cabinet or chassis
• Prevents loose or vibrating parts and associated rattling noises
• Keeps connectors and small components properly positioned
• Replaces broken or missing clips that allow gaps or misalignment

• One plastic retainer clip

• Disconnect power to the appliance before starting any work
• Typically a push-fit or snap-in replacement; may require a flat tool or trim tool to remove/install
• Inspect mating mounting surfaces and replace any damaged retainers or broken bosses

This small plastic retainer secures an appliance wire harness to the cabinet or internal components to prevent rubbing and strain on connections. Replacing a damaged clip helps keep wiring routed correctly and reduces the risk of intermittent electrical issues. What it does:

• Holds the wire harness in place to prevent chafing and contact with moving or hot parts
• Keeps connectors and wires from pulling loose during normal use
• Helps prevent intermittent power or control problems caused by loose wiring
• Reduces vibration noise from loose harnesses

• Disconnect power to the appliance before servicing to avoid shock or injury
• Inspect surrounding wiring and routing before removing the old clip
• The clip typically snaps into a mounting hole or channel; align harness and press until it seats
• Use common hand tools if needed; replace any damaged wiring or connectors found during installation