Jenn-Air Parts

• Fridge runs too long
• Noisy
• Freezer section too warm
• Fridge too warm

After reviewing the 'how to' video on AppliancePartsPros.com, I unplugged the refrigerator and removed the back cover to access the motor. I then unplugged the wiring and removed the bad motor. I cut the clip plug and wired it to the new motor, installed the fan blade from the old motor and re-installed the new motor. After connecting the clip plug and re-installing the back cover, I plugged the refrigerator in and checked the interior about 5 minutes after the repair. Everything has been... Read more

• Noisy
• Fridge runs too long
• Fridge too warm
• Freezer section too warm

Unplugged refrigerator and removed access panel from back of fridge. Have had this panel off many times for dust removal. Panel is a cheap piece of glorified cardboard on this Whirlpool model, which is a shame given that it was a $1000 refrigerator. Fan motor is mounted on stamped sheet metal bracket which I removed from cabinet with old fan attached to it. Metal bracket held in place by 4 1/4 inch hex head sheet metal screws. Two outermost screws can be removed with nut driver but access to... Read more

You'll need a screwdriver with one of those small square heads and a small socket wrench. Remove ice bin. Unscrew 2 screws on casing surrounding the ice box in order to lift it up and out. Remove 4 screws from plastic piece beneath the ice box that the coupling is mounted to and is part of the ice chute. No need to remove coupling as you can lift this piece out (carefully) with it in tact. If you haven't already, unplug the fridge or turn off the breaker. [I didn't do this sooner because I... Read more

Remove the ice bucket remove screws from one side of shaft remove screws from other end of shaft replace moter easy fix Read more

After researching the problem, I ordered a new cooling fan. My "fix-it" guy winds up in the ICU for 3 weeks! So...YouTube here I come. It appeared pretty simple in video form, except the video wasn't of my stove. All in all, what looked like no more than a 6 screw removal, turned into tearing 1/2 the stove apart. Still, only took about 2 hours start to finish. Best lesson learned, turn off the energy efficiency mode!!! Read more

If the freezer is cold and the fridge is hot, logic would indicate that the fan blowing the cold air from the freezer into the refrigerator is not working. Searched the ApplicancePartsPros.com website for a fan in the freezer compartment and found the video on how to replace one. Followed the steps in the video to get the freezer partially disassembled and found the whole back of the freezer frozen over. Plugged the refrigerator back in and verified that the fan was not working. Unplugged... Read more

• Freezer section too warm

The fan has a very thin wire in it's coil, and when that wire breaks, you need a new fan. In a previous repair, i noticed that an ice build-up had dislodged the wiring on my fan and severed the coil winding. I was able to undo the winding a couple of turns and get it working again. But more recently, the fan stopped and there was no repairing it. So i ordered a new fan from AppliancePartsPros.com and it got here in very good time. The new fan was slightly different as the prongs seemed to be... Read more

Removed the back cover to access the fan area. Clean the area with brush and vac first. Unplugged the Refrigerator. Used a socket set with 1/4" socket. Had an extended and a standard socket. Removed the condensate plastic drain from the bottom of the refrigerator to have more access to the fan. Unplugged the fan motor. Removed the two screws holding the fan in place. Removed the fan unit from the condenser side of the bracket. Place new fan on the fan and installed exactly the way I removed the... Read more

I bought the listed condenser fan motor for my Maytag refrigerator. Access to the condenser fan is by removing sheet metal screws of bottom panel with 1/4 in. nut driver. Condenser fan is on left side of rear access area. Remove electrical connector by pressing-in connector release tab with thumb fingernail and pulling on connector. Remove three mounting screws with 5/16 nut driver. Work fan out to the right past the compressor. I used a pair of pliers, as a lever, behind the plastic fan blades... Read more

I ordered a new motor with a very helpful Chris.It arrived a day later with instructions and was easy to exchange with the old one.I am delighted with how it works and the price was good and the service excellent.thank you. Read more

I first thought it was the auger in the ice container so I changed it and it was not the problem. I then talked to ApplianceParts customer service that it might be the yoke on the motor that turned the auger or even the motor itself even though it worked. I ordered the parts, the yoke was supposed to be able to be changed by itself but mind would not come off the motor shaft so I had to cut it off just to remove it from the unit so I had to change the motor anyway because of this. So I advise... Read more

My KitchenAid refrigerator was not cooling, but the freezer was working perfectly. The help section here listed three parts that could be defective–defrost thermostat, evaporator fan motor and blade, and air diffuser/damper control–so I replaced them all. The videos were EXCELLENT, and despite the difficulty I had squeezing my shoulders into the small freezer compartment, I installed the parts and my refrigerator is cooling perfectly! THANK YOU FOR THE EXCELLENT REPAIR VIDEOS! I am so happy... Read more

First, I did online research to find out what could be the problem with these symptoms of cold freezer and warm fridge. I found multiple posts with people going back and forth as far as what to do to fix it. One tread even provided the link to your store with the part number for the evaporator fan motor. So I did the inspection of the motor as suggested by the expert and sure enough it was the evaporator's motor fan that was not working as it should. That is when I immediately follow the link... Read more

The repair went well. Never made this type of repair before. Took me around 90 minutes to complete. The worst part was winging it on how to disassemble the bottom drawers. On my Kenmore Elite, it has three freezer compartment sliding trays. The other difficult part for me was removing the clipped in part on the back of the freezer panel. Without knowing what to do it was a little frustrating. after getting to the evaporator unit, removing built-up ice and replacing the unit was fairly easy. The... Read more

I received my new part in about 3-4 days. Part was exact match for my existing motor. After watching the installation video on this website I was able to garner the rudimentary directions to replace the motor. The video did not match the exact fridge I had. My fridge did not have the access panel on the interior of the freezer. I had to remove the two screws at the water ice dispenser tray on the outside and slide that unit off the front. Before removing the motor, open the freezer and remove... Read more

After checking the suggested fixes and parts on Appliance Parts Pros, I ordered the defrost thermostat and evap motor for my refrigerator, a Kitchen Aid KSSC42QTS00. Installation was very easy, simply emptying the freezer and removing the access panel in the back bottom half. Upon getting everything open, I found out that the existing evap motor was working fine, so I didn't install that part. I did install the defrost thermometer, which was a 5-minute process. I also cleared out the vent... Read more