Jenn-Air Range Switch

I was able to clean the Oven Temp Sensor with 99% alcohol. Then replaced All switches (after breaker was isolated). Put it all back the way I found it. Turned on breaker. Tested all functions and had no reports of Fan Code re-appearing since. Read more

Replaced the Infinite Switch and that solved the problem. Did not need to replace the Surface Element Read more

Replaced switch Read more

After looking at several YouTube videos that were only moderately helpful for my particular model, I disconnected the power at the breaker, disconnected the wires below the cooktop to the junction boxed lifted the whole unit out, including the fan assembly. I flipped it upside down and took off the screws holding the unit to the glass top. Although the new fan switch did not look the same as the original switch, the new switch does fit. The new switch did not come with a hex nut. The old hex... Read more

Replaced switch assembly Read more

I looked up the parts on appliancepartspros.com, made the order, and was amazed how fast the parts arrived! I was able to watch their repair video and it showed me how to change it step by step. Read more

• Won't start

By replacing the switch, the front right burner correctly turned on the igniter and worked. Repair took about 5 minutes. Very easy to do. Read more

Went on line to find the part number. Once I had the number I searched for the part. Found it, had it shipped overnight and installed it with the help of a video from youtube. Read more

I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes. Read more

Ordered the part and a few days later it arrived and I turned off the power and took a few screws out and unpluged the old one and pluged in the new .. Works like a charm.. Was very easy to fix.... Read more

A few weeks back, when shutting off a burner, the igniter started sparking and wouldn't stop. Working the knobs and jiggling them got it to stop. Fast forward a few weeks. Finish cooking, go sit down to eat. Hear snapping noise, go look, see burners are all off and the igniters are all sparking. Jiggle the knobs. Poof! Flames come out the top one! What a stink. Unplugged stove, finished dinner. Loosened the cooktop and investigated. Ordered switch. Two days later, part arrives. Two screws... Read more

Watched appliance parts pros video on YouTube to determine which part to replace. Ordered parts and followed how to video and replaced parts. Read more

I changed out the white burners for black ones which will be easier to clean. This is a simple matter of removing two screws on each burner. The one igniter switch turned out to be okay, but was not fully seated on the valve shaft. As to lighting off issues, the new burners helped, but the most improvement came from removing the burners and cleaning the orifices that supply gas to the burner tubes with a bit of fine wire. Read more

Removed rocker switch,made up jumper so the compactor could be used while awaiting replacement switch. The part came 2 days later and was installed in less tha 5 minutes. Unit working like new again. Thanks for the great service!! Read more