Kenmore / Sears Cooktop Parts

Bought new burner tops for all four burners. Lights great now with nice blue flames and no yellow. Read more

I ordered 7 new lens caps to replace them all. Took ten minutes to fix. Read more

Replaced igniter and orifice assembly, and replaced spark module. Used the video for help, but the video doesn't show the top cover piece that needs to be taken off first. Also the screws for the igniter set were stuck from old grease or something and had to be drilled out. Overall the project was well worth my time for the cost vs replacement decision. AppliancePartsPros.com makes it so easy to choose a part and guesstimate the probably of choosing the right one. Read more

Removed the element "easy just four screws" unplugged two connecting wires, removed element. Did a "continuity test" on element, it failed, so I ordered a new one and installed it. It works great now. Read more

Very easy replaced switch. Read more

Replace the burner part that was broken. Read more

Replaced the part and it works great. Thanks! Read more

You were right on with your evaluation. I Replaced the board, and we seem to be like new. Thanks Read more

• Timer will not advance

Replaced above parts, easy to do, looks like a new stove. Needed to pry open knob stem slot segments very slightly to remove broken plastic from previous knobs. Spreading stem slot metal sides too much and they will break. With slots cleaned out, pinch stem sides almost together for new knobs to slide on. Customer service rep was helpful and parts delivery was next day as promised. Before contacting Appliance Parts Pros, I found their on-line customer reviews were much better than their... Read more

The problem is a finicky ignition system, Direct Spark Ignition. Apparently Whirlpool redesigned the igniter/burner assembly slightly to make it more reliable. The repair is very easy. Turn off power, but you don't need to turn off gas. Remove oven bottom and flame spreader, then remove burner/igniter assembly, one screw at front, one at back. Lift out burner assembly carefully to avoid stretching wire. Pull electric connector from pin on burner/igniter assembly. Vacuum to clean oven. ... Read more

Installed it according to video watched. Read more

• Won't start

Replaced module: Although the new module was slightly different due to a third or ground terminal that was not on the original I managed to figured out that I did not need to worry about the ground since the existing wiring had already allowed for the connection. Easy repair. I ordered the part one day and it was delivered the next and that was using the least expensive delivery service. You guys are great Read more

It was very easy caled up ordered the part no prblem got it in 3 days.Got a phillips screw driver removed the top of the stove took out the old one a put in the new one had it fixed within minutes very easy diy no need to pay someone alot of money for this easy fix. Read more

Removed door. Viewed You Tube video. Trial and error. . Read more

• Noisy

I used a set of ring pliers to remove the old retaining ring, then spread the plastic ribs around the fan motor shaft with a small flat bladed screwdriver to ease removal of the old fan blade. I reversed the process to replace the blade, gently tapping a socket from my socket wrench set placed over the motor shaft and ribs with a small rubber mallet. I stopped when the shaft protruded about 1/8" beyond the plastic ribs of the new fan blade, then installed the new retaining clamp ring with the... Read more