Kenmore / Sears Cooktop Parts

Easy just pull clip and put back Read more

Slipped the old ones out, slid the new ones in. So simple, even my husband could do it! Read more

I had one element that would operate wide open when turned on the low setting. It needed the switch replaced. Since I was replacing other elements I went ahead replaced them all, adding new drip pans and wiring kits to each new element. Once I replaced everything I was still having issues with the element that had the switch replaced. After further investigation my AC voltage readings were not correct at this element. I traced the problem back to the Molex connector feeding voltage to the... Read more

• Element will not heat

Purchased a new Element surface and installed same... All Okay now... Read more

With the help of Wendee and Karen, we finally figured out my model numbers and which parts where correct. I ordered the parts and all arrived the next day except for the Broiler element which arrived in 2 days. I installed the new Baking Element myself. Took longer to figure out which curcuit braker to turn off. In about 30 minutes I had a brand new Baking Element in my oven working perfectly. On the following day, I installed the Broiler Element. That took a bit longer as it sits in a metal... Read more

Replaced the control board and panel. Read more

I purchased 2 new light rocker switches, Because the heating element rocker switch was unavailable. First I removed the power source for safety. Then I simply pulled each switch out individually with a flathead screwdriver for leverage. I simply unplugged the wires from the old rocker switch, discarded the old rocker, plugged the wires into the new rocker switch, and pushed the new switch appropriately back into the control panel. I used the same steps for both rocker switches. Once... Read more

• Won't start

Bought this switch gas valve for the non-functional burner, and it cleared right up. Read more

Ordered new heating coils for stove Read more

I first tried to purchase the part directly from GE but they were not helpful at all. Remembering that I had purchased a transmission and other parts from appliance parts pros for my old Maytag washer before, I searched their easy-to-use parts catalog and there it was!!!! I asked for confirmation from Customer Service and after 2 says Research confirmed that it was the correct part. Replacing the element was quite simple following the very helpful diagrams on their website. Thank you so very... Read more

Turned off power to oven. Removed the oven door. Unscrewed and removed the metal plate. Pulled element off wires and attached them to the new element. (This took needle nose pliers and many attempts. Needed dexterous fingers and good eyesight.) Put everything back. Read more

Everything was straight forward and easy to repair, I had an appliance tech come out and troubleshoot the repair and watched what he did and asked questions. I then ordered the parts from here and did the repairs myself and saved on having the tech make another trip out. Read more

Replaced the control board. Read more

Little procrastination paid off. With only 50% capability I knew it is time to call the appliancepartspros. They shipped me parts within 3 days. It was practical to fix both at the time. All I needed was to disconnect power at range breaker box, grab a screwdriver to lift top open, a 16 inch or so piece of old 2×4 wood to keep the top top of stove lifted, so I could access heating elements from underneath. Then I took my black sharpie And marked location of mounting screws and... Read more

Attached new leg and leveled the range. Read more