Kenmore / Sears Range Parts

I had one element that would operate wide open when turned on the low setting. It needed the switch replaced. Since I was replacing other elements I went ahead replaced them all, adding new drip pans and wiring kits to each new element. Once I replaced everything I was still having issues with the element that had the switch replaced. After further investigation my AC voltage readings were not correct at this element. I traced the problem back to the Molex connector feeding voltage to the... Read more

Replaced burner with new. Did the trick. Works like new. Read more

I had to order the glass, frame, and cap that the handle attaches to. I just had to put in about 6 screws, it was very simple. Read more

Changed element Read more

I replaced both the probe and temp control. The problem came in calibrating the new control, the instructions that came with control did not factor in a double oven, called back and talked to Michael at tech support and he found proper instructions, walked me through the process and sent me a PDF file with all information needed. I can't thank Michael and AppliancePartsPros.com enough for their service after the sale. I would definitely recommend and use it again. Read more

• Won't start

First, it was going to cost $95 for an appliance guy just to look at it! I figured there would be an upcharge on the parts + labor on top of the $95, so I took a chance & decided my husband & I could fix it cheaper; we were right, but it was a 3 week process (luckily, we have another microwave in the basement we were able to use in the meantime). I googled the microwave model #, then price checked the same item I thought we needed; printed off the diagrams of the various microwave "systems" &... Read more

Replaced Read more

Ordered new heating coils for stove Read more

Replaced all ignitors. Read more

• Little to no heat when broiling
• Element will not heat

Quick shipping, easy repair. Read more

Se above Read more

Read trouble guide then watched video Ordered part on friday,received it on monday easy install,stove works like new. ApplianceParts Pros wed was very helpfull Thankyou Read more

• Little to no heat when broiling

Cut off power ,inside I remove the two back screws, remove the two front screws with hangers. Pull element out, clip wires so they don't fall back in holes with clothes pins. worked good. But wire connection to the broiler was to large, had to replace connectors, wire fell in hole, had to pull wall oven out and remove back panel. I then mounted the new element to oven. Replaced connectors ,connected connectors, closed back panel, put oven in place ,connected power lines. Turned power on. Works... Read more

I found AppliancePartsPros.com while surfing the web and made my call; knowing nothing about the site or company. In a nutshell, I do not know if the price I paid for the item was competitive, but the representative I spoke to was extremely knowledgeable; helped me locate the part I needed immediately; and completed the entire transaction in which seemed like 60 seconds. The part arrived 2 days later and was EXACTLY what I needed and a PERFECT match to the other shelves in my refrigerator... Read more

Replacing the trim takes a little bit of alignment and light force. The trim slides over the glass panel of the door, with the glass sliding into plastic tabs. We kept the door nearly vertical (almost closed), lined up the tabs on the trim with the glass door, and used mild force to slide the trim down onto the glass door. (Also, we found that the tabs on trim we ordered were much bigger than the tabs on our broken trim. This is probably due to slight variations in Frigidaire's design over... Read more

Replaced the control board. Read more