Kenmore / Sears Range Parts

Replaced parts. Getting the top off was a little tricky but watched a you tube video and it was simple. Read more

• Door stuck closed

Turn off breaker, remove all screws { 4 on mine } inside oven door holding oven and microwave to kitchen cabinet and slide oven assembly out of cabinet {on to a temporary shelf of {4} 5 gallon buckets/plywood/bricks/shims that I made on the floor atop a scrap of carpet} just enough to access the side and rear screws of microwave's protective metal housing, then remove a total of 16 screws { there were 2 screws just inside top of "opened" microwave door that were holding top flat silver metal... Read more

• Little to no heat when broiling

Come to find out after replacing the element, it is the control card Read more

I installed a new clock timer and overlay the job took only a few minutes and a very easy repair. Useful hint take a picture of your clock timer before you start to make sure all your wires are put back in the right order . Charles B Lafayette Tn Read more

Replaced all ignitors. Read more

Pulled out the old one, popped in the new one 20 minutes. Fixed. Read more

Easy just pull clip and put back Read more

Slipped the old ones out, slid the new ones in. So simple, even my husband could do it! Read more

I had one element that would operate wide open when turned on the low setting. It needed the switch replaced. Since I was replacing other elements I went ahead replaced them all, adding new drip pans and wiring kits to each new element. Once I replaced everything I was still having issues with the element that had the switch replaced. After further investigation my AC voltage readings were not correct at this element. I traced the problem back to the Molex connector feeding voltage to the... Read more

• Element will not heat

Purchased a new Element surface and installed same... All Okay now... Read more

With the help of Wendee and Karen, we finally figured out my model numbers and which parts where correct. I ordered the parts and all arrived the next day except for the Broiler element which arrived in 2 days. I installed the new Baking Element myself. Took longer to figure out which curcuit braker to turn off. In about 30 minutes I had a brand new Baking Element in my oven working perfectly. On the following day, I installed the Broiler Element. That took a bit longer as it sits in a metal... Read more

Replaced the control board and panel. Read more

I purchased 2 new light rocker switches, Because the heating element rocker switch was unavailable. First I removed the power source for safety. Then I simply pulled each switch out individually with a flathead screwdriver for leverage. I simply unplugged the wires from the old rocker switch, discarded the old rocker, plugged the wires into the new rocker switch, and pushed the new switch appropriately back into the control panel. I used the same steps for both rocker switches. Once... Read more

• Won't start

Bought this switch gas valve for the non-functional burner, and it cleared right up. Read more

Ordered new heating coils for stove Read more

I first tried to purchase the part directly from GE but they were not helpful at all. Remembering that I had purchased a transmission and other parts from appliance parts pros for my old Maytag washer before, I searched their easy-to-use parts catalog and there it was!!!! I asked for confirmation from Customer Service and after 2 says Research confirmed that it was the correct part. Replacing the element was quite simple following the very helpful diagrams on their website. Thank you so very... Read more