Kenmore / Sears Range Parts

• Door won't open or close

The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more

My husband replaced the part in less than fifteen minutes. It would have been quicker if the screws had been included! Read more

Bought black ones to replace them. They look great and match the black burner grates and pans I had bought previously. Good service from you. Read more

I replaced the drip pans, grates, knobs, grease filter and downdraft grate. I have a new stove top! All for a fraction of the cost of a new one. Read more

I replaced the Gas Range Broil Burner Spark Electrode Read more

I found AppliancePartsPros.com while surfing the web and made my call; knowing nothing about the site or company. In a nutshell, I do not know if the price I paid for the item was competitive, but the representative I spoke to was extremely knowledgeable; helped me locate the part I needed immediately; and completed the entire transaction in which seemed like 60 seconds. The part arrived 2 days later and was EXACTLY what I needed and a PERFECT match to the other shelves in my refrigerator... Read more

I replaced both the large single element and the large dual element control switches. It appears the resistors were burning out. Problem seems to be fixed. Will know later when I do some simmering. Read more

I discovered the oven thermocouple was broken and burned off at the end. This prevented the oven pilot to remain lit after releasing the oven control knob. I ordered a new thermocouple which was part of the oven burner assembly. The oven now works just fine. Read more

The problem was partly caused because the original legs were at full extension. The replacement legs were longer than the originals and were more secure at the needed length. One difficulty was that the threaded base plate where the legs screwed in had been damaged and had to be reshaped, I was able to reshape the sockets with some effort, to allow the legs to thread in, though one remained slightly angled. (A metal tool of some type which could be threaded in and used to bend the socket area... Read more

The drip pans I ordered fit my stove perfectly. I was extremely happy. I had tried drip pans from Wal Mart and Lowe's and they wouldn't sit right in the stove. Read more

Check problem solutions on your website. Very easy to I'd problem. Ordered part reviewed repair video. Made the repair...very easy with video help. Saved time and money.. Stove working great again Read more

A new ignitor was installed, and a new light switch was installed Read more