Kenmore / Sears Washer Dispenser Parts

This dispenser assembly mounts in the refrigerator door to provide a stable dispensing point for ice and water and restore normal use of the door dispenser. It replaces damaged or worn dispenser components to stop leaks and restore proper operation. What it does:

• Provides the exterior opening and actuator area for dispensing ice and/or water
• Guides and supports the dispense lever or actuator and related components
• Helps prevent leaks and dripping from the door dispense area
• Commonly replaced when the dispenser won't actuate, leaks, or has broken trim or lever

• Disconnect power and shut off the water supply before starting
• Door panel or inner liner removal may be required for access
• Handle trim and plastic parts carefully to avoid cracking during removal/installation
• Follow the refrigerator's service manual or tech sheet for torque and routing details

This dispenser drawer handle trim assembly replaces the trim and handle piece on the refrigerator dispenser drawer for a clean, finished look and reliable grip. It restores proper drawer operation and user access to the dispenser area. What it does:

• Replaces damaged, cracked, or worn dispenser drawer trim and handle for improved appearance
• Provides a secure grip to open and close the dispenser drawer smoothly
• Helps keep the dispenser opening sealed and aligned for normal drawer function
• Addresses visible cosmetic damage and loose or broken handle symptoms

• High-level replacement; typically requires removing the drawer or access panel—refer to your model's service diagram
• Disconnect power to the appliance before starting work to avoid injury
• Handle parts may snap or screw into place; save any retaining clips or screws from the old part for reuse

This detergent dispenser box is the molded housing that holds and guides liquid or powder detergent inside the washer dispenser assembly, helping deliver detergent into the wash at the proper time. What it does

• Houses detergent and channels it to the washer's wash tub during the cycle
• Prevents detergent from spilling or pooling in the dispenser area
• Helps ensure measured detergent flows into the machine when the cycle starts
• Common symptom: detergent stays in the drawer or does not fully dispense

• Disconnect power (and water if applicable) before service
• Handle the housing carefully to avoid cracking plastic tabs or seals
• Inspect adjoining seals, slides, and mounting clips and replace if worn
• Refer to the washer's service manual or exploded parts diagram for correct removal and reassembly