Kenmore / Sears Washer Screws, Nuts, Washers

A replacement hex washer-head screw used to secure panels and components in commercial washers and dryers. Replaces a worn or missing fastener to restore proper fit and reduce rattling or loose parts. What it does:

• Fastens panels, brackets, and assemblies with a hex washer-head profile for a secure hold
• Restores proper alignment when loose or missing screws cause vibration or rattling
• Keeps components seated to prevent wear or snagging during operation
• Compatible where the OEM specifies part number 51782

• Use the correct hex driver or socket to avoid stripping the head
• Thread engagement and torque should follow the appliance manufacturer's specifications
• Do not overtighten; overtightening can strip threads or deform mounting surfaces
• Disconnect power and follow safety procedures before servicing the appliance

Size: 10 - 24 x 3/8

This is a replacement mounting screw used to secure panels, brackets, or components on compatible Whirlpool appliances. It restores proper fastening to reduce looseness and rattling and keep parts aligned for safe operation. What it does

• Fastens trim, panels, brackets or assemblies to the appliance chassis
• Restores secure attachment when original screw is missing, loose, or stripped
• Helps stop vibration-related noise and movement of panels or covers
• Supports correct alignment of components to prevent wear or interference

• Disconnect power to the appliance before beginning any service.
• Start threads by hand to avoid cross-threading; tighten snugly but do not overtighten.
• Keep removed screws organized so replacements go back to their original locations.

This is a single replacement screw used to secure appliance panels and components. It restores proper fastening to help eliminate looseness and rattling and keep parts aligned for safe operation. What it does:

• Secures trim, panels or internal components to maintain proper alignment
• Prevents rattling or vibration caused by loose fasteners
• Replaces missing or stripped screws for safe, reliable fit
• Works wherever the OEM screw specification and fit match the original

• One screw as shown

• Disconnect power and/or gas before accessing internal components
• Use the proper driver size and avoid over-tightening to prevent thread damage
• Verify correct screw placement against the appliance's service diagram

This 8-18 x 2.000 screw secures appliance panels and components, providing a reliable fastener replacement for restoring proper fit and reducing rattles or loose parts. Use where the original long 8-18 screw is required. What it does:

• Fastens appliance panels, brackets, or components where an 8-18 x 2.000 screw is specified
• Restores secure mounting to stop panel movement, rattling, or misalignment
• Matches OEM thread size and length for direct replacement when the original screw is missing or damaged
• Safe for interior and exterior appliance applications where an 8-18 machine screw is used

• Turn off and unplug the appliance before replacing any fasteners
• Use the correct screwdriver or bit to avoid stripping the head
• Install in the same location and orientation as the original screw; do not overtighten
• If replacing screws in structural or load-bearing locations, all surrounding fasteners are secure