Kitchenaid Compressor & Sealed System

Fix a refrigerator that won't cool or runs constantly with this compressor. Essential sealed system component. Professional installation recommended.

Fridge not cooling or freezer not cold? The compressor circulates refrigerant to cool your appliance. Professional installation required for this repair.

Refrigerator not cooling or running too warm? A failed compressor stops refrigerant circulation. This is an advanced repair requiring special tools.

Refrigerator not cooling or freezing? This compressor powers your cooling system. Professional installation recommended due to sealed system work.

Refrigerator not cooling or making unusual noises? This compressor tubing kit repairs sealed system issues. Advanced repair requiring proper tools.

Fix a refrigerator that won't cool or runs but produces no cold air. This compressor requires professional installation due to refrigerant handling.

Refrigerator not cooling or running warm? This compressor pumps refrigerant through the sealed system to restore proper temperatures. Professional repair.

Fix inconsistent cooling or refrigerant leaks in your side-by-side refrigerator. This heat transfer tube routes refrigerant for proper temperature control.

This replacement tube routes fluids within the appliance to restore proper water flow and prevent leaks. It's a direct-fit service part that replaces a worn, cracked or damaged tube so the appliance moves water where it should. What it does

• Channels water/condensate between components to maintain normal operation
• Helps stop leaks or puddling caused by a cracked or split tube
• Reduces poor performance symptoms tied to restricted or damaged tubing
• Restores the original routing and connection points when properly installed

• One replacement tube as shown

• Inspect routing and connection points; replace any damaged clamps or grommets
• Turn off power and water supply before starting any repair
• Use proper clamps to secure both ends and check for leaks after reassembly

Refrigerator not cooling or running constantly? This compressor is the heart of your cooling system. Professional installation strongly recommended.

Refrigerator not cooling or running constantly? The compressor circulates refrigerant to maintain proper temperature. Expert-level repair component.

Fix a warm refrigerator and freezer or loud rattling noise during operation. This compressor repairs cooling failures from sealed system issues.

This replacement water fill tube routes water to the appliance's dispenser/ice system so you get proper fill and reduced leaks. It restores reliable water delivery when the original tube is cracked or clogged. What it does:

• Directs water from the supply to the dispenser or ice/water mechanism
• Prevents leaks when intact and properly secured
• Helps ensure consistent water flow for ice makers and dispensers
• Worn or damaged tubes can cause pooling, low water delivery, or intermittent filling

• One replacement water fill tube

• Turn off the appliance power and water supply before starting work
• Inspect fittings and seals; replace clamps or gaskets if worn
• Slide tube into place and secure with the original or new clamps for a leak-free connection

Refrigerator not cooling or making unusual noises? This compressor system tube connects critical sealed system components for proper refrigerant flow.

This replacement tube routes water where the appliance needs it and restores proper flow when the original tube is cracked or blocked. It's a direct-fit plumbing piece used inside the appliance to channel water safely. What it does:

• Carries water between internal components to enable normal appliance operation
• Helps prevent leaks when intact and correctly installed
• Replaces tubes that are cracked, split, clogged, or otherwise damaged
• Can stop symptoms like intermittent draining, visible leaking, or reduced water flow

• Disconnect power and shut off the water supply before starting any repair
• Verify tubing orientation and secure all fittings and clamps to prevent leaks
• Inspect adjacent fittings and seals; replace any worn hardware to ensure a tight connection