Kitchenaid Gas Conv Kit Parts

Orifice spud for gas range burners. Threads into the manifold to regulate gas flow. Replace if cracked, stripped, or missing during fuel conversion.

Orifice spud secures the burner orifice to the gas valve/manifold and directs fuel to the burner for proper flame performance. Replaces a damaged or corroded spud to help restore correct gas flow at the burner. What it does:

• Holds the burner orifice in place and channels gas from the valve to the burner.
• Helps maintain consistent flame size for even heating and cooking.
• Commonly used when a burner has weak, uneven, or intermittent flame performance.
• Replace if the spud is cracked, corroded, damaged, or leaking.

• Turn off the appliance's gas supply and disconnect power before beginning any repairs.
• Remove burner components per the service manual and install the spud in the same orientation as the original.
• Hand-start threads, then snug with the appropriate wrench—do not overtighten.
• After installation, check fittings for leaks with an approved leak-detection method; if you smell gas or suspect a leak, stop.

Replace a clogged, damaged, or missing gas burner orifice on your range or cooktop. This brass fitting meters gas flow to maintain proper flame size.

This gas burner orifice spud regulates gas flow to your range's burners. Replace if cracked, clogged, or damaged to restore proper burner operation.

Complete conversion kit with orifices and fittings to change your gas cooktop from natural gas to propane or vice versa. Needed when relocating or changing fuel source.

Burner orifice spud for gas cooktops. This brass fitting installs on the burner assembly to regulate gas flow. Replace if worn or damaged.

This metal fitting meters gas flow to your range burner. Replace a clogged, damaged, or missing orifice to restore proper gas distribution and flame control.

Converts your natural gas cooktop to run on liquid propane. Includes orifices, valve components, and hardware for safe fuel type conversion.

This fitting connects a hose or pipe to the appliance to create a secure fluid connection, helping prevent leaks and restore proper water or fluid flow. It's a small but essential plumbing connector used in supply and drain lines. What it does:

• Provides a sealed connection between appliance tubing and a fixture or valve
• Restores secure water/fluid flow when a worn or damaged connector is causing leaks
• Helps stop drips or intermittent flow caused by loose or corroded fittings
• Works as the link between rigid pipes and flexible hoses in supply/drain assemblies

• Turn off water supply and unplug the appliance before starting work
• Inspect mating tubing and seals; replace damaged hoses or O-rings as needed
• Hand-start threads to avoid cross-threading; tighten following OEM torque guidance
• If threads are present, use plumber's tape only where the OEM specifies; avoid over-tightening

Replace a cracked, worn, or missing burner orifice spud on your cooktop. This brass fitting controls gas flow to the burner and may need replacement.

This gas burner orifice controls gas flow to your range burner. Replace if cracked, clogged, or incorrectly sized for your fuel type conversion.

Gas burner orifice for ranges. Regulates gas flow to burners. Replace if clogged, damaged, or when converting fuel types. Installs in burner assembly.

Orifice holder for gas ranges. Secures the gas orifice in the burner assembly. Replace if cracked, broken, or missing to ensure proper orifice fit.

Replacement burner orifice for gas ranges and cooktops. Brass fitting that controls gas flow to each burner. Replace if damaged, worn, or missing.

Replacement orifice holder for gas cooktops. Secures the gas orifice in place within the burner assembly. Order a new holder if damaged or missing.