Kitchenaid Range Parts

You have to take the knob off the broken part, then buy the new switch element and fix it. To do this you turn the power off, take out 6 fasteners to release the front panel of the stove and replace the switch element. Then put it all back together. Very simple. But if the knob was designed better it would not have broken in the first place. It looks nice, but this is the third time I have had to fix one. Read more

Replaced it myself. Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

Replaced fuse. It took much longer to get the oven out of the wall to access the fuse and replace the front panel than to do the repair. This fuse failed at the end of the cleaning cycle for the bottom oven and left the door locked because the open fuse removed the 120v power from the control board. The locked door made it impossible to remove one of the screws holding the wall oven in place. However, after I ground off the head of the screw behind the edge of the locked door I was able to... Read more

Replaced the thermst-fix and the thermal fuse oven now works great Read more

• Won't start

Replaced module: Although the new module was slightly different due to a third or ground terminal that was not on the original I managed to figured out that I did not need to worry about the ground since the existing wiring had already allowed for the connection. Easy repair. I ordered the part one day and it was delivered the next and that was using the least expensive delivery service. You guys are great Read more

• Door won't close

Replaced the hinge and receiver. Read more

Replaced bake element to no avail, seeking help with live chat. FYI, order process and delivery time was top notch. Read more

Replace the burner part that was broken. Read more

My husband had been searching for replacement parts of over a year. I found your website and asked one of your employees... received a response the following day and ordered the parts! Super simple, and now I have new foot pads that fit my stove burner grates. Thanks so much! Read more

We replaced both front orifice holders. Very easy to bend and break. If it has a deep bend in it, It will slow down the gas flow to the burner. if you have a low gas flow your burner will burn low So check your small silver gas lines and if you smell gas check your lines Read more

I replaced the old burner with the new burner assembly which included the ignighter. The screw that held the old ignighter was frozen into the old burner such that just the ignighter could not be replaced. Be care full removing the screws to the burner as they also may be frozen and tend to snap off instead of unscrewing. You will need to drill an tap new holes. Read more

Replacing the oven knob sensor was easy. Figuring out it was the sensor causing the circuit breaker to trip was the challenge. Read more

Using the parts I ordered, I replaced the glass myself following the very helpful video on your web site. Read more

Your on line video pointed out the problem, how to test, and how to replace the element. I ordered the part it came the next day. Wife is very happy. Read more