Kitchenaid Refrigerator Filter

Replaced the old housing with new water filter housing. Read more

The video was very helpful, but my KitchenAid model required slightly more steps. Only the two screws in front held the filter housing, same as the video shows, but it has to be removed from the rear. My model did not have the wire brace, only the two front screws held the housing. Shut the water off and pull the electrical plug. Remove the two screws holding the filter housing in the front. Remove the lower panel in the rear at the bottom of the refrigerator. Remove the two screws holding the... Read more

Ordered a new one Read more

Replaced housing. That was simple but finding directions in how it I remove top of cabinet was time consuming. After two hours of searching I finally found one article that explained why there were no screws to remove. Read more

It's bit of a chore in that on my Whirlpool Refrig you need to remove the grill on bottom front and the Utility Panel on bottom rear. Then unscrew the original filter housing and pull it out through the back of utility opening. Remove the two water hoses and put them into new filter house. Reverse the disassembly process to reinstall new filter housing. I'm old and slow so the process took me about 45 minutes. (Note: Unplug electric and turn off water inlet before starting.) Read more

Disconnect the housing carefully from water line (push and release) and replace with new parts Read more

Replaced water filter housing. Read more

Went on internet, found a great site and learned that the cold water hose filter was very much clogged at the machine intake. Cleaned it and voila. Ordered an extra filter from Appliance Pros.com and literally was amazed that it arrive within 2 days of my internet order. Great efficiency and customer service….great experience. Will definitely use them in the future….thank you! Read more

Changed out the water filter housing. Read more