Lg Drum, Bulkhead, Front Parts

The Tub Assembly is an OEM component for LG clothes dryers. As the central component housing both the inner and outer drums, the tub assembly is essential for safely drying wet laundry loads. It rotates the drums to circulate air and remove moisture from clothes during cycles. 

Causes of a bad tub assembly dryer can include cracks, leaks, or damage to the drum structure from excessive use or unbalanced loads over time. Wear and tear on rotating or suspension components that impair rotation. 

Symptoms of an issue with the tub assembly dryer are:

• Inefficient or slow drying times 
• Abnormal noises or vibrations during cycles
• Restricted or lack of drum rotation
• Cracks, leaks, or physical damage visible on drums

This OEM LG part is also compatible with Sears/Kenmore.

This tub cover replaces the outer tub housing panel and helps protect internal wash components from water and debris while maintaining proper drum alignment. It restores the appliance cabinet integrity and supports reliable washer operation. What it does:

• Covers and protects the washer's outer tub and internal components from splashes and foreign objects
• Helps maintain proper spacing and support for the wash drum
• Can reduce water leakage paths around the tub area when installed correctly
• Addresses symptoms such as visible damage to the tub housing, loose or sagging tub trim, or water spray reaching internal components

• One tub cover

• Disconnect power and water before starting any repair
• Remove the washer cabinet or front panel as required to access the outer tub; refer to model-specific service instructions
• Inspect surrounding seals, fasteners, and mounting clips and replace any damaged pieces

This washer tub assembly is the stationary outer tub that surrounds the spin basket and contains the wash water. Replacing a cracked or damaged tub helps stop leaks and restores proper clearance for smooth, quiet washing and spinning.

• Creates a watertight chamber around the basket to hold wash and rinse water
• Maintains proper basket clearance; damage can cause rubbing or scraping sounds
• Provides connection points for hoses and water-level components
• Common signs it may be needed: leaks from the tub area, visible cracks or warping, persistent out-of-balance/spin errors, or internal scraping/grinding noises

• Disconnect power and water; shut off supplies and safely drain remaining water
• This is a major repair—allow time and consider a second person to help lift/support the tub
• Transfer model-specific parts from the original tub to the new tub as needed; reinstall all clamps, bolts, and sensors securely
• After reassembly, level the washer, and run a test cycle to check for leaks