Need Help?
Call
Dishwasher leaking from bottom or making grinding noise? The sump housing often cracks or wears out. Moderately difficult repair, about 45 minutes.
I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more
This is the heating element located at the bottom of the dishwasher tub. It heats the water during the wash and rinse cycles and provides heat for the drying cycle. Replace this element if dishes come out wet or poorly cleaned, the water is not getting hot enough, or if the element is visibly damaged or broken.
Number one was turn the power to the dishwasher off. I disconnected the hoses under the sink. The dishwasher had to be pulled out from the cabinet. The old heating element easily came out and the new one put in its place. The instructional video made the repair very easy. Read more
Fix a dishwasher that stops mid-cycle with a blinking start light. This door interlock switch restores reliable operation. 20-minute DIY repair.
Looked online, appeared to be door switch or control panel. Tried door switch first, a $30 part. Installed new door switch and washer started right up and appears to be fixed. Have not tried full wash cycle yet, but problem appears to be fixed. I decided to buy part from AppliancePartsPros.com because I could return the part if it did not correct the problem, no one else offered such a deal. I will only deal with AppliancePartsPros in the future, they were extremely helpful on the phone! Read more
Dishwasher not spraying or making loud buzzing noise? Replace the pump and motor assembly. Moderate DIY repair takes 2-3 hours with basic tools.
Checked the grinder/pump well at the bottom of the dishwasher and fished out some aluminum foil, wire twist ties, broken plastic forks, etc. That was fun but it didn't solve the problem. Purchased new pump & motor assembly and installed it as per Youtube video. It requires pulling out the dishwasher, disconnecting electric, hotwater, and drain lines, and then removing a bunch of clips and connectors. That was time consuming but basically easy ... except that seating the new assembly gasket... Read more
This factory-spec screw secures panels and components in your appliance. Replacing a missing or stripped fastener restores a tight, rattle-free fit so parts stay aligned and operate as designed.
Replaced Wheel-Tub. Read more
Soap or rinse aid dispenser not opening? This wax motor actuates the dispenser door release. DIYers report 15-30 minute repairs with basic tools.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
Color: White. This basket measures about 9 inches wide by 7 inches high by 6 inches deep. The cover and handle are not included. The cover is no longer available. For the handle order W11033847.
Bought a new one that you had available. Best reliable source I have found to date. Read more
Replacement upper spray arm for dishwashers. Installs on the top rack level to restore water distribution. Replace if cracked, clogged, or broken.
This is a 12 year old Kenmore, but my experience applies to many dishwashers. The machine had run for almost a year without being cleaned. I found parts had failed from age and water passages were jammed with hard-water deposits and pieces of food, labels, etc. that had gotten past the filters. I cleaned out what I could and replaced parts that could not be cleaned or were damaged. Dishwasher now works better than it has for years. The work, including ordering parts, took about 4 hours, but... Read more
Secures the dishwasher's water inlet tube in position, preventing movement and strain on fittings. Replace if cracked, broken, or missing to restore support.
We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more
Replaces cracked, broken, or missing lower access panel on your dishwasher. Covers the base opening for a finished look and shields internal parts.
Leaking around the pump motor shaft? This dishwasher impeller and seal kit stops leaks from worn seals. Moderate DIY repair with video guide included.
Ordered the replacement pump seal kit from AppliancePartsPros. I watched the online how-to video on their website. The impeller was slightly stuck on the motor shaft due to age but overall was amazed at how easy it was to repair. Thanks AplianePartsPros! Read more
Fix dispenser door that won't latch or leaks at the door bottom. This grommet and latch kit stops water leaks. Requires inner door panel removal.
The grommet was old and very caked with old dishwasher scum. So water was leaking through where the soap door latch goes into the door. I replaced the rubber grommet (and the plastic latch that came with the kit, even though the old one was probably fine). Fit perfectly and looked just like the old one. Works like a champ, no leaking! Read more
Seals the coupler connection on portable dishwashers to prevent leaks at the faucet adapter. Replace when worn, cracked, or flattened to stop drips.
Replaced the coupler gasket. No leaks now. Read more
12 Ft in length
Read directions on how to change the power cord and watched video on your site on how to change the drain hose. Everything went perfectly. Read more
Replacement tub wheel assembly for dishwasher upper rack track. Installs on inner tub to support rack gliding. Needed when wheel is cracked or broken.
Replaced left hand rack adjuster. Read more
Fix a dishwasher that won't drain or leaks from the pump area. This pump housing assembly replaces the seal connection between motor and tub. DIY repair.
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.