Magic Chef Dishwasher Parts

Without knowing exactly what broke I ordered 2 springs and 2 door spring links. I knew the door springs were weak and a parts man told me many years ago to always replace BOTH springs or the one you didn't replace will soon break. It is a simple procedure, just remember how the springs/links are attached. make a simple drawing or take a picture should you need it. I watched two "how to" video's which made it look harder to do than it really is. Turn the circuit breaker off and turn the... Read more

We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more

I ordered a new one. Read more

Appeared to be two problems: the latch was worn and one of the pins that slid in a guide on the actuator located in the inner panel had broke off. Detergent lid spring and pin appeared to be OK but decided to replace since I was aready working on it. I ordered all the inner panel mechanism from the control arm to the latch actuator on the inner panel. The repair was successful as the detergent dispenser now opens during its cycle. Read more

Read directions on how to change the power cord and watched video on your site on how to change the drain hose. Everything went perfectly. Read more

Used the vinyl touch up paint on the tops of posts and slid vinyl tips over 130 posts. The paint acts as an adhesive to keep the tips secure. Read more

Motor shaft was stripped, replaced with new shaft from Motor Seal Kit. Impeller was also cracked, so replaced it as well. I did run in to a small problem, the chopper blade was pressing against the metal grate on the piece that goes back over the motor seal. I spent about an hour messing with it, but thought maybe once it's all together it'll be fine. When you screw the impeller on, it pushes down the seals, which pushes down the chopper blade. Video on Motor Seal Kit page made it an... Read more

Replaced the fuse resistor and the heating element. Read more

We bought replacement parts from you and my daughter fixed it. It is working now. It would have been nice if all the parts came in a set. Read more

• overflowing

Replaced the water inlet valve and float switch. Read more

Ordered a new pump Read more

• Not drying dishes properly
• lights flashing or blinking

Number one was turn the power to the dishwasher off. I disconnected the hoses under the sink. The dishwasher had to be pulled out from the cabinet. The old heating element easily came out and the new one put in its place. The instructional video made the repair very easy. Read more

Ordered dishwasher rack tine tips and bottle of vinyl touch up paint. I applied the paint to each tine and then placed the tips on the tines. I waited a few hours before using my dishwasher to allow the paint to dry and allow the tips to stick to the tines. Read more

I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more

I took a multimeter and found out that the old fuse was open. I ordered this new one and popped it in. Pretty easy fix and it's still going strong. Read more

Purchased door springs from Appliance Parts pros.com, installed them and door on our Dishwasher was back to normal, Had to pull out dishwasher from under cupboard to get to springs, as they were on the sides of the dishwasher. Read more