Maytag Refrigerator Gasket & Seal

Let the gaskets straighten out a bit overnight. Pulled out the old gasket, Cleaned and dried the area well though almost all the mold was in the old gasket. Pressed in the new gasket. Use a hairdryer to warm up and press the slightly deformed areas of the gasket into place. Quick and EASY. Read more

Removed the worn gasket, cleaned the door, snapped on the new gasket. Read more

Ordered new gasket seals and had someone install them, Installed one prior myself and it was very difficult to heat and stretch and wrap doors. Ended up gouging my cabinet when stretching the seal . Leave for professionals and even they struggled. Tight now and working great. Read more

• Door sweating

New seal, old one pulled out easy and new one pushed into place. Read more

It was not hard at all to replace our refrigerator door gasket. First I found appliancepartspros.com because I was looking up on YouTube how to do the replacement. Your video was excellent and showed me that I indeed could perform the job. I had a question about the replacement door gasket and emailed your service team at the end of the day. By next morning you had replied with the actual part number for the gasket. Shipping was fast. I had watched the video several times and so performed... Read more

Replaced a new rubber seal, it took me approx forty minutes. It works perfect, the door seals correct now. Thanks to the instruction supplied from appliance parts pros.com. Read more

First had to clean inside the empty freezer, that was the hard part. removed old gasket and cleaned inside the track in the door. had the new gasket well warmed and in the right shape. put new gasket in track. seating it firmly. It was very easy. I did watch a couple of online videos to get the general idea of what it detailed. While I was at it I cleaned the coils with the brush I also bought with the gasket, worked great. all in all if you get organized before hand and take your time,... Read more

My husband followed the instructions on the video. Read more

Replaced gasket. Read more

Replaced door seal Read more

Replace with new Read more

I pulled the old gasket off the door then I used rubbing alcohol to clean the mold along the back of the door and in the insert for the gasket seals . The new gasket fit extremely well and was very easy to put in. I waited 24 hours for the gasket to come back to its normal shape. After putting the gasket in I waited another 24 hours to make sure that I was getting no Icing inside the freezer area. There was no icing so the job is completed. Read more

Watched the Youtube video suggested. It was a piece of cake to change out the gasket. Read more